The theology of fresh cement pastes is difficult to obtain and data is often difficult to reproduce. Factors involving mixing, testing techniques, test geometries, etc contribute to the measurement problems. This review addresses these problems and comments on the analysis of experimental data. This
The rheology of fresh cement paste containing polysaccharide gums
โ Scribed by Virgilio A. Ghio; Paulo J.M. Monteiro; Laura A. Demsetz
- Publisher
- Elsevier Science
- Year
- 1994
- Tongue
- English
- Weight
- 439 KB
- Volume
- 24
- Category
- Article
- ISSN
- 0008-8846
No coin nor oath required. For personal study only.
โฆ Synopsis
The addition of polysaccharide gums to cement pastes has a considerable effect on their rheological properties. These admixtures are currently used in several practical applications such as anti-bleeding agents, anti wash out admixtures, and pump and sag resistance additives. The success of these applications depends on the rhcological properties of the grout. Experimental results reported here show that the addition of polysaccharide galmq in cement paste systems has a significantly higher effect on the viscosity at low shear rates than at higher shear rates. Additionally, a considerably high thixotropic behavior has been found in the form of an apparent viscosity recovery, this effect being higher for combinations of the polysaccharide gum and high range water reducers.
๐ SIMILAR VOLUMES
The following paper presents the results of the research carried out to investigate the influence of alkalis built in clinker phases and introduced from the outside together with make-up water, on the rheological properties of pastes in Portland cement at an early stage of hydration (less than 1 hou
Results are presented ~rom measurements o{ the permeability o~ saturated, hardened cement pastes, with and without fly ash.Specimens tested were cured over a temperature range from 20 to 65ยฐC for periods from seven days to one year. The results show that a dramatic reduction in permeability occurs d
Fresh cement slurries typical of those used in the oil industry during drilling operations are assessed for the growth of structure in the first few hours after mixing by the use of shear modulus and ultrasonic pulse velocity measurements. It is shown that during the first two hours, the shear modul