✦ LIBER ✦

The processing of hardmetal components by powder injection moulding

✍ Scribed by M.T. Martyn; P.J. James

Book ID: 113302730
Publisher: Elsevier Science
Year: 1993
Tongue: English
Weight: 825 KB
Volume: 12
Category: Article
ISSN: 0263-4368
DOI: 10.1016/0263-4368(93)90017-a

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Powder injection moulding of bimetallic

Powder injection moulding of bimetallic components

📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 140 KB

Fabrication of ceramic micro-scale hollo

Fabrication of ceramic micro-scale hollow components by micro-powder injection moulding

✍ Usama M. Attia; Jeffrey R. Alcock 📂 Article 📅 2012 🏛 Elsevier Science 🌐 English ⚖ 937 KB

Preparation of tungsten carbide-cobalt h

Preparation of tungsten carbide-cobalt hardmetals by metal injection moulding

📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 154 KB

Numerical Simulation of the Powder Injec

Numerical Simulation of the Powder Injection Moulding Process for Optimization of Mould Design and Process Parameters

✍ V. V. Bilovol; L. Kowalski; J. Duszczyk 📂 Article 📅 2000 🏛 John Wiley and Sons 🌐 English ⚖ 246 KB 👁 2 views

Processing of hardmetal components by po

Processing of hardmetal components by powder injection moulding: M.T. Martyn, P.J. James (Loughborough University of Technology, Leicestershire, England), Int J Refractory Metals & Hard Materials, Vol 12, No 2, 1993–1994, 61–69.

📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 137 KB

Characterisation of micro gears produced

Characterisation of micro gears produced by micro powder injection moulding

✍ B.Y. Tay; N.H. Loh; S.B. Tor; F.L. Ng; G. Fu; X.H. Lu 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 564 KB

The paper describes the fabrication of micro gears of diameter and height 1 mm by micro powder injection moulding. 316L stainless steel powder of 2.4 µm (d 50 ) is mixed with a multi-component wax-based binder system. The feedstock is then injection-moulded into micro gears followed by debinding and