๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Fabrication of ceramic micro-scale hollow components by micro-powder injection moulding

โœ Scribed by Usama M. Attia; Jeffrey R. Alcock

Book ID
113708579
Publisher
Elsevier Science
Year
2012
Tongue
English
Weight
937 KB
Volume
32
Category
Article
ISSN
0955-2219

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Characterisation of micro gears produced
Characterisation of micro gears produced by micro powder injection moulding
โœ B.Y. Tay; N.H. Loh; S.B. Tor; F.L. Ng; G. Fu; X.H. Lu ๐Ÿ“‚ Article ๐Ÿ“… 2009 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 564 KB

The paper describes the fabrication of micro gears of diameter and height 1 mm by micro powder injection moulding. 316L stainless steel powder of 2.4 ยตm (d 50 ) is mixed with a multi-component wax-based binder system. The feedstock is then injection-moulded into micro gears followed by debinding and

Constitutive modelling of microstructure
Constitutive modelling of microstructured components fabricated by micro powder injection molding
โœ L. Liu; N.H. Loh; B.Y. Tay; S.B. Tor; Y. Murakoshi; R. Maeda ๐Ÿ“‚ Article ๐Ÿ“… 2008 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 597 KB

A constitutive model based on Besson and Abouaf's constitutive equation was established to simulate densification of 316L stainless steel microstructured components fabricated by micro powder injection molding. A new sintering stress expression for final stage sintering was established by including