Relative densities and massic heat capacities have been determined for the amino acids L-lysine monohydrochloride and L-arginine monohydrochloride in aqueous solution at the temperatures T = (288. 15, 298.15, 313.15, and 328.15) K. These data have been used to calculate apparent molar properties whi
The partial molar heat capacities of glycine and glycylglycine in aqueous solution at elevated temperatures and atp =  10.0 MPa
✍ Scribed by Colin J. Downes; ; Andrew W. Hakin; ; Gavin R. Hedwig
- Publisher
- Elsevier Science
- Year
- 2001
- Tongue
- English
- Weight
- 189 KB
- Volume
- 33
- Category
- Article
- ISSN
- 0021-9614
No coin nor oath required. For personal study only.
✦ Synopsis
Apparent molar heat capacities have been determined for aqueous solutions of glycine at temperatures from 352.09 K to 470.63 K and glycylglycine at temperatures from 352.09 K to 423.15 K. Both systems were investigated at a pressure of 10.0 MPa. Measurements were performed with a differential flow calorimeter that is capable of operation at temperatures >723 K and pressures to approximately 40.0 MPa. Partial molar heat capacities at infinite dilution have been calculated from apparent molar values and have been corrected for "relaxation" contributions. The reported partial molar heat capacity values for aqueous glycine and glycylglycine solutions have been modelled using the revised Helgeson, Kirkham, and Flowers semi-empirical equations of state. These models for solutions of glycine and glycylglycine in water have been compared with those previously reported in the literature.
📜 SIMILAR VOLUMES
Density data for dilute aqueous solutions of benzoic acid and three hydroxybenzoic acids obtained in the temperature range 298.15 K to 498.15 K and at either atmospheric pressure or at pressures close to the saturated vapour pressure of water and at elevated pressures up to 30 MPa are presented alon
Density data for dilute aqueous solutions of aniline (aminobenzene) in the range T = 298.15 K to T = 573.15 K and at either atmospheric pressure, or at pressures close to the saturated vapour pressure of water and at elevated pressures up to p = 30 MPa are presented, together with partial molar volu
Apparent molar heat capacities φC p and volumes φV of seven monosaccharides {D(-)ribose, D(-)-arabinose, D(+)-xylose, D(+)-glucose, D(+)-mannose, D(+)-galactose, D(-)-fructose}, seven disaccharides {sucrose, D(+)-cellobiose, lactulose, D(+)-melibiose hemihydrate, D(+)-maltose monohydrate, D(+)-lacto
Density data for dilute aqueous solutions of two isomeric aminobenzoic acids and of o-diaminobenzene (1,2-diaminobenzene) are presented together with partial molar volumes calculated from the experimental data. The measurements were performed at temperatures from 298.15 K up to either 498.15 K (amin