✦ LIBER ✦

The measurements of drag resulting from small surface irregularities immersed in turbulent boundary layers

✍ Scribed by M. G. Higazy; D. J. Cockrell

Publisher: Springer
Year: 1984
Tongue: English
Weight: 399 KB
Volume: 2
Category: Article
ISSN: 0723-4864
DOI: 10.1007/bf00571865

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Measurements of turbulence structure in

Measurements of turbulence structure in the boundary layer on a rough surface

✍ J. Andreopoulos; P. Bradshaw 📂 Article 📅 1981 🏛 Springer 🌐 English ⚖ 737 KB

Mean products of velocity fluctuations up to fourth order have been measured in a wind tunnel at the trailing edge of a flat plate, one side of which was covered with floor-sanding paper to produce a fully rough surface. This set-up permits easy comparison of structural parameters in smooth-wall and

The measurement of ∂u∂y in a turbulent b

The measurement of ∂u∂y in a turbulent boundary layer over a riblet surface

✍ Y. Dubief; L. Djenidi; R.A. Antonia 📂 Article 📅 1997 🏛 Elsevier Science 🌐 English ⚖ 455 KB

Comparing Estimates of Turbulence Based

Comparing Estimates of Turbulence Based on Near-Surface Measurements in the Nocturnal Stable Boundary Layer

✍ Florence Bocquet; Ben Balsley; Michael Tjernström; Gunilla Svensson 📂 Article 📅 2010 🏛 Springer 🌐 English ⚖ 851 KB

Spectral Structure of Small-Scale Turbul

Spectral Structure of Small-Scale Turbulent and Mesoscale Fluxes in the Atmospheric Boundary Layer over a Thermally Inhomogeneous Land Surface

✍ Michail A. Strunin; Tetsuya Hiyama 📂 Article 📅 2005 🏛 Springer 🌐 English ⚖ 859 KB

Influence of velocity gradient and wall

Influence of velocity gradient and wall proximity on the readings of a pitot tube in measurement of surface friction and velocity distribution in a turbulent boundary layer

✍ E. U. Repik; V. K. Kuzenkov; N. P. Mikhailova 📂 Article 📅 1985 🏛 Springer US 🌐 English ⚖ 613 KB

Determining the quantity of material wor

Determining the quantity of material worn away from a wall in a turbulent boundary layer as a consequence of chemical erosion when an inert inhomogeneous gas is added by injection through the entrained surface under conditions of substantial nonisothermicity

✍ A. I. Leont'ev; É. P. Volchkov; E. G. Zaulichnyi 📂 Article 📅 1969 🏛 Springer US 🌐 English ⚖ 344 KB