A simple model is deduced for the surface layer of a convective boundary layer for zero mean wind velocity over homogeneous rough ground. The model assumes large-scale convective circulation driven by surface heat flux with a flow pattern as it would be obtained by conditional ensemble averages. The
β¦ LIBER β¦
Influence of velocity gradient and wall proximity on the readings of a pitot tube in measurement of surface friction and velocity distribution in a turbulent boundary layer
β Scribed by E. U. Repik; V. K. Kuzenkov; N. P. Mikhailova
- Publisher
- Springer US
- Year
- 1985
- Tongue
- English
- Weight
- 613 KB
- Volume
- 48
- Category
- Article
- ISSN
- 1573-871X
No coin nor oath required. For personal study only.
π SIMILAR VOLUMES
Minimum friction velocity and heat trans
β
Ulrich Schumann
π
Article
π
1988
π
Springer
π
English
β 901 KB
Correlation between the longitudinal vel
β
R.A. Antonia; L.V. Krishnamoorthy; L. Fulachier
π
Article
π
1988
π
Elsevier Science
π
English
β 764 KB
Distribution of mass velocities of water
β
A. D. Rekin
π
Article
π
1979
π
Springer US
π
English
β 609 KB
Turbulent natural convection in a dihedr
β
J.C. Elicer-CortΓ©s; Doan-Kim-Son
π
Article
π
1991
π
Elsevier Science
π
English
β 456 KB
A note on the height dependence of the s
β
Osamu Chiba
π
Article
π
1984
π
Springer
π
English
β 375 KB
Several experimental results indicate that S, (the skewness of the vertical turbulent velocity) increases with height, and K, (the kurtosis) decreases with height in the neutral surface layer. The measured behavior of S, and K, with height under neutral conditions is shown to be consistent with avai
Comments on βa note on the height depend
β
George TreviΓ±o
π
Article
π
1986
π
Springer
π
English
β 113 KB