𝔖 Bobbio Scriptorium
✦   LIBER   ✦

The fluid mechanics and heat transfer of injection mold filling of thermoplastic materials

✍ Scribed by Youti Kuo; Musa R. Kamal

Publisher
American Institute of Chemical Engineers
Year
1976
Tongue
English
Weight
895 KB
Volume
22
Category
Article
ISSN
0001-1541

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Effect of Processing Parameters on the M
Effect of Processing Parameters on the Mechanical Properties of Injection Molded Thermoplastic Polyolefin (TPO) Cellular Foams
✍ Steven Wong; John W. S. Lee; Hani E. Naguib; Chul B. Park πŸ“‚ Article πŸ“… 2008 πŸ› John Wiley and Sons 🌐 English βš– 356 KB πŸ‘ 1 views

## Abstract In this study, the effects of processing parameters on the mechanical properties of injection molded thermoplastic polyolefin (TPO) foams are investigated. Closed cell TPO foams were prepared by injection molding process. The microstructure of these foamed samples was controlled by care

Influence of mold filling rate and gate
Influence of mold filling rate and gate geometry on the modulus of high pressure injection-molded polyethylene
✍ A. Boldizar; J. KubΓ‘t; M. Rigdahl πŸ“‚ Article πŸ“… 1990 πŸ› John Wiley and Sons 🌐 English βš– 487 KB πŸ‘ 1 views

High pressure injection molding of HDPE with relatively high molecular weight is known to give products with significantly increased modulus and strength. The extent of this improvement is reduced when the thickness of the molded sample increases. The present paper is an account of experiments with