𝔖 Bobbio Scriptorium
✦   LIBER   ✦

The effect of phase instability of stainless steel on the cladding deformation profiles of LMFBR fuel elements

✍ Scribed by Gerard L. Hofman; L.C. Walters; G.L. McVay

Publisher
Elsevier Science
Year
1977
Tongue
English
Weight
558 KB
Volume
67
Category
Article
ISSN
0022-3115

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Effect of Alloying Elements on the Rate
Effect of Alloying Elements on the Rate of Growth of Individual Pits on Stainless Steels
✍ Marinovich, Y. ;Fukutsuka, T. ;Matsuo, Y. ;Sugie, Y. πŸ“‚ Article πŸ“… 2008 πŸ› Curtin University of Technology 🌐 English βš– 699 KB

## Abstract Potentiodynamic polarization curves of five different commercially available stainless steels (SS) were measured in air‐saturated 0.5 M NaCl (25dΜ€C, pH = 5.2). This data gave useful information on the corrosion behavior of the alloys in this system. It was found that the potential at wh

The effect of multiple circumferential t
The effect of multiple circumferential through-wall cracks in the same cross-section on the fracture instability of a stainless steel pipe subject to bending deformation
✍ E. Smith πŸ“‚ Article πŸ“… 1987 πŸ› Elsevier Science 🌐 English βš– 293 KB

This paper examines the fracture instability of a pipe, fabricated from a ductile material such as 304 stainless steel, in which a circumferential cross-section contains two symmetrically situated through-wall cracks, the pipe being subject to bending deformation. The theoretical analysis, which is

The effect of mechanical deformation on
The effect of mechanical deformation on magnetic properties and MRI artifacts of type 304 and type 316L stainless steel
✍ Lee P. Bendel; Frank G. Shellock; Mark Steckel πŸ“‚ Article πŸ“… 1997 πŸ› John Wiley and Sons 🌐 English βš– 737 KB

The purpose of this study was to evaluate the influence of composition and deformation of biomedical stainless steels on mechanical properties, magnetic properties, and MRI artifacts. Type 304 and Type 316L samples were prepared using standard wire-drawing techniques. Mechanical properties were dete