## Abstract By using remote plasma atomic layer deposition (ALD), ruthenium thin films were deposited on SiO~2~ using bis(ethylcyclopentadienyl)ruthenium [Ru(EtCp)~2~] as a Ru precursor and an ammonia plasma as a reactant. Different plasma treatments were applied, and the best results were obtained
The effect of oxygen remote plasma treatment on ZnO TFTs fabricated by atomic layer deposition
โ Scribed by Lee, Seungjun ;Bang, Seokhwan ;Park, Joohyun ;Park, Soyeon ;Jeong, Wooho ;Jeon, Hyeongtag
- Publisher
- John Wiley and Sons
- Year
- 2010
- Tongue
- English
- Weight
- 358 KB
- Volume
- 207
- Category
- Article
- ISSN
- 0031-8965
No coin nor oath required. For personal study only.
โฆ Synopsis
Abstract
We deposited ZnO thin films by atomic layer deposition (ALD) and then investigated the chemical and electrical characteristics after plasma treatment. The chemical bonding states were examined by Xโray photoelectron spectroscopy (XPS). The XPS spectra of O 1s showed that the intensity of oxygen deficient regions of the ZnO film decreased from 27.6 to 19.4%, while the intensity of the oxygen bound on the surface of the ZnO film increased from 15.0 to 21.9% as plasma exposure times increased. The ZnO film exhibited a decrease in carrier concentration from 4.9โรโ10^15^ to 1.2โรโ10^14^โcm^โ3^ and an increase in resistivity from 1.2โรโ10^2^ to 9.8โรโ10^3^โฮฉโcm as the plasma exposure times increased. To verify the changes in the chemical and electrical properties of the ZnO films caused by the oxygen remote plasma treatment, ZnO thin film transistors were fabricated and their electrical properties were investigated. We found that the I~on/Ioff~ ratio increased from 7.3โรโ10^4^ to 8.6โรโ10^6^, the subthreshold swings improved from 1.67 to 0.45โV/decade, and the saturation mobility (ยต~sat~) decreased from 1.63 to 0.72โcm^2^/Vโs as plasma exposure times were increased.
๐ SIMILAR VOLUMES
## Abstract In this study, the effects of postannealing on ZnO and Al~2~O~3~ films grown for a thinโfilm transistor (TFT) by the atomic layer deposition (ALD) method were examined using transmission electron microscopy (TEM) and energyโdispersion spectroscopy. Samples were subjected to rapid therma
## Abstract The effect of heat treatment on the gas barrier of the polymerโcoated board further coated with an Al~2~O~3~ layer by atomic layer deposition (ALD) was studied. Heat treatment below the melting point of the polymer followed by quenching at room temperature was used for the polylactideโc