✦ LIBER ✦

The Effect of Initial Microstructure of A356 Alloys on the Mechanical Behavior in the Semisolid State

✍ Scribed by Ning, Zhi Liang; Wang, H.; Sun, Jianfei

Book ID: 120018084
Publisher: Trans Tech Publications, Ltd.
Year: 2006
Tongue: English
Weight: 244 KB
Volume: 116-117
Category: Article
ISSN: 1662-9779
DOI: 10.4028/www.scientific.net/SSP.116-117.449

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Thixotropic behavior and structure evolu

Thixotropic behavior and structure evolution of A356 alloy in the semisolid state

✍ Yang, Y.S.; Tsao, C.-Y.A. 📂 Article 📅 1994 🏛 Elsevier Science ⚖ 541 KB

Mechanical behavior of alloys with equia

Mechanical behavior of alloys with equiaxed microstructure in the semisolid state at high solid content

✍ E. Tzimas; A. Zavaliangos 📂 Article 📅 1999 🏛 Elsevier Science 🌐 English ⚖ 769 KB

Rheological behavior, microstructure and

Rheological behavior, microstructure and hardness of A356 aluminum alloy in semisolid state using backward extrusion process

✍ S.A. SADOUGH; M.R. RAHMANI; V. POUYAFAR 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 721 KB

The influences of the microstructure mor

The influences of the microstructure morphology of A356 alloy on its rheological behavior in the semi-solid state

✍ Zhu, Yuefeng; Tang, Jinglin; Xiong, Yizhi; Wu, Zhenning; Wang, Chen; Zeng, Daben 📂 Article 📅 2001 🏛 Institute of Physics and National Institute of Mat 🌐 English ⚖ 259 KB

Extrusion behavior of Al-Cu alloys in th

Extrusion behavior of Al-Cu alloys in the semisolid state

✍ B.S. Lee; D.H. Joo; M.H. Kim 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 730 KB

Microstructure and mechanical properties

Microstructure and mechanical properties of extruded Al–Si alloy (A356) in the semi-solid state

✍ M.A. Bayoumi; M.I. Negm; A.M. El-Gohry 📂 Article 📅 2009 🏛 Elsevier Science ⚖ 1000 KB

Smooth round bars were produced from conventional non-modified cast alloy, A356, by semi-solid extrusion after isothermal holding in mushy zone. Extrusion process was carried out in an apparatus, designed and prepared for this purpose at a ram speed, 2.5 mm/s. Three forming temperatures: 560, 570 an