𝔖 Bobbio Scriptorium
✦   LIBER   ✦

The effect of heater plate thickness on boiling heat-transfer coefficients

✍ Scribed by T.L. Chuck; J.E. Myers


Publisher
Elsevier Science
Year
1978
Tongue
English
Weight
556 KB
Volume
21
Category
Article
ISSN
0017-9310

No coin nor oath required. For personal study only.


πŸ“œ SIMILAR VOLUMES


Effects of heater and heating methods on
✍ S. M. Lu; D. J. Lee πŸ“‚ Article πŸ“… 1989 πŸ› American Institute of Chemical Engineers 🌐 English βš– 298 KB πŸ‘ 2 views

In a pool boiling from an electrically-heated wire, there are three modes of boiling: nucleate, film, and coexisting nucleate and film boiling. These are shown in Figure 1. The latter has been studied by Semeria and Martinet (1 9 6 9 , Kovalev (1 966), Van Ouwerkerk (1972), and Madsen (1973,1979). Z

Pool boiling heat transfer in binary mix
✍ Toshiaki Inoue; Masanori Monde; Yoshio Teruya; Hideki Ikeda πŸ“‚ Article πŸ“… 2002 πŸ› John Wiley and Sons 🌐 English βš– 188 KB

## Abstract Nucleate boiling heat transfer coefficients were measured on a horizontal heated wire during the pool boiling of non‐azeotropic mixtures of ammonia/water. The experiment was carried out at pressures of 0.4 and 0.7 MPa, at heat fluxes below 2.0 Γ— 10^6^ W/m^2^, and over a range of mass fr

Decrement estimation of the heat transfe
✍ Junjie Gu; Hans-jΓΆrg Bartf πŸ“‚ Article πŸ“… 1999 πŸ› John Wiley and Sons 🌐 English βš– 619 KB

Based on the analysis of the principles of heat and mass transfer from the liquid bulk to bubble surface during nucleation, a new theoretical method to predict the heat transfer of the nucleate pool boiling in binary mixtures is proposed in this paper by using the heat and mass transfer analogy (Col