๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

The calculation of cooling time in injection moulding

โœ Scribed by J.Z. Liang; J.N. Ness

Publisher
Elsevier Science
Year
1996
Tongue
English
Weight
266 KB
Volume
57
Category
Article
ISSN
0924-0136

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Automatic layout design of plastic injec
Automatic layout design of plastic injection mould cooling system
โœ C.L. Li; C.G. Li; A.C.K. Mok ๐Ÿ“‚ Article ๐Ÿ“… 2005 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 981 KB

This research extends our previous investigation of the automation of the preliminary design stage to the layout design stage of the cooling system design process. While the functional aspects of the cooling system are considered during the preliminary design stage, the layout design stage addresses

Injection moulding of thermosets. Effect
Injection moulding of thermosets. Effect of the temperature of injection
โœ H. Hadi; K. Azaar; A. El Brouzi; R. Granger; J.M. Vergnaud ๐Ÿ“‚ Article ๐Ÿ“… 1993 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 491 KB

In order to reduce the cycle time of cure of thermosets, one of the best method is to use a system of injection moulding. This system enables one to inject the thermoset at a higher temperature than room temperature in the heated mould. Thus the heating period of the resin may be significantly reduc