✦ LIBER ✦

The application of a microcomputer to the control of an injection moulding machine

✍ Scribed by T.P. Leung; H.K. Fung; C. McCall

Publisher: Elsevier Science
Year: 1988
Tongue: English
Weight: 749 KB
Volume: 10
Category: Article
ISSN: 0166-3615
DOI: 10.1016/0166-3615(88)90017-6

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Optimal open-loop control of the mould f

Optimal open-loop control of the mould filling process for injection moulding machines

✍ Y. J. Cho; H. S. Cho; C. O. Lee 📂 Article 📅 1983 🏛 John Wiley and Sons 🌐 English ⚖ 726 KB

Injection moulding of thermosets. Effect

Injection moulding of thermosets. Effect of the temperature of injection

✍ H. Hadi; K. Azaar; A. El Brouzi; R. Granger; J.M. Vergnaud 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 491 KB

In order to reduce the cycle time of cure of thermosets, one of the best method is to use a system of injection moulding. This system enables one to inject the thermoset at a higher temperature than room temperature in the heated mould. Thus the heating period of the resin may be significantly reduc

Modelling of neural controllers with app

Modelling of neural controllers with application to the control of a machining process

✍ M. Balazinski; E. Czogala; T. Sadowski 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 554 KB

Application of generalised predictive co

Application of generalised predictive control to the paper machine benchmark

✍ C.-M. Chow; A.G. Kuznetsov; D.W. Clarke 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 337 KB

This paper presents an application of Generalised Predictive Control (GPC) to the paper machine benchmaxk. The plant features a relatively large dead-time and severe retention level variation at the wire section. From simulations, results show that the controller has good performance when the the re

The effect of shear controlled orientati

The effect of shear controlled orientation in injection moulding on the mechanical properties of an aliphatic polyketone

✍ Gürhan Kalay; Michael J. Bevis 📂 Article 📅 1997 🏛 John Wiley and Sons 🌐 English ⚖ 762 KB

This article relates to an investigation of injection moulding a new commercial polymer, an aliphatic polyketone (PK). A terpolymer and a 30% glass-filled grade were used as study materials together with an isotactic polypropylene that was used as a basis for comparison. Both conventional injection

A New Approach to the Optimization of Bl

A New Approach to the Optimization of Blends Composition in Injection Moulding of Recycled Polymers

✍ G. Lucchetta; P.F. Bariani; W.A. Knight 📂 Article 📅 2006 🏛 International Academy for Production Engineering 🌐 English ⚖ 165 KB

The use of recycled polymers is widespread for the injection moulding of many commodity plastic parts. Recycled polymers are usually blended with virgin polymers to obtain the best trade-off between cost and low melt viscosity. This last constraint is necessary to avoid short shots and to minimize t