𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Surface grafting of polyethylene by mutual irradiation in methyl acrylate vapor

✍ Scribed by F. Yamamoto; S. Yamakawa

Publisher
Elsevier Science
Year
1981
Weight
531 KB
Volume
18
Category
Article
ISSN
0146-5724

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Graft copolymerization of 4-vinylpyridin
Graft copolymerization of 4-vinylpyridine and methyl acrylate onto polyethylene film by radiochemical method
✍ Inderjeet Kaur; B. N. Misra; Anupam Gupta; Ghanshyam S. Chauhan πŸ“‚ Article πŸ“… 1998 πŸ› John Wiley and Sons 🌐 English βš– 341 KB πŸ‘ 2 views

Graft copolymerization of 4-vinyl pyridine (4-VP) and methyl acrylate (MA) onto polyethylene (PE) was studied in aqueous medium in air by the mutual irradiation method. The percentage of grafting was determined as a function of the (i) total dose, (ii) monomer concentration, and (iii) amount of wate

The surface modification of polyethylene
The surface modification of polyethylene by solution-phase photochemical grafting using short irradiation times
✍ L. M. Hamilton; A. Green; S. Edge; J. P. S. Badyal; W. J. Feast; W. F. Pacynko πŸ“‚ Article πŸ“… 1994 πŸ› John Wiley and Sons 🌐 English βš– 520 KB

The surface modification of low-density polyethylene by solution-phase photochemical grafting with acrylic acid and acrylamide is described. After irradiation for 3 min, the contact angles of the modified surfaces with water were ca. 20, 30, and 40Β°C and ca. 40, 40, and 80Β°C for grafting solutions c

The effect of the type of polyethylene o
The effect of the type of polyethylene on the grafting of styrene on polyethyleneβ€”I. Direct radiation grafting and grafting by pre-irradiation in vacuo
✍ F. Ranogajec; I. Dvornik; J. DobΓ³ πŸ“‚ Article πŸ“… 1970 πŸ› Elsevier Science 🌐 English βš– 519 KB

The influence of the type of polyethylene on the rate and yield of grafting of styrene was studied by using simultaneous irradiation with -r-rays and also pre-irradiation in vacuo. By both methods, the grafting yield was found to be higher in high density polyethylene, except at low temperature with