In this paper, the axisymmetric dynamic behavior and snap-through buckling of thin elastic shallow spherical shells under harmonic excitation is investigated. Based on Marguerre kinematical assumptions, the governing partial differential equations of motion for a pre-loaded cap are presented in the
Steady-State and Transient Behavior of Organic Electrochemical Transistors
✍ Scribed by D. A. Bernards; G. G. Malliaras
- Publisher
- John Wiley and Sons
- Year
- 2007
- Tongue
- English
- Weight
- 244 KB
- Volume
- 17
- Category
- Article
- ISSN
- 1616-301X
No coin nor oath required. For personal study only.
📜 SIMILAR VOLUMES
Output beam spatial properties of a dual wavelength CW DPSS laser have been studied using the thermal lens (photothermal) effect. In employing the __Z-scan__ technique both the steady-state and time-dependent thermal lens signal as a function of sample position could be examined simultaneously. The
The differences between the diffusivities obtained by rate of sorption and steady state experiments are analysed. Any noticeable difference between steady state and transient diffusivities are attributable to the fact that the diffusion process is concentration dependent. However, the average or app
Refocused steady-state free precession (SSFP) imaging sequences have recently regained popularity as faster gradient hardware has allowed shorter repetition times, thereby reducing SSFP's sensitivity to off-resonance effects. Although these sequences offer fast scanning with good signal-to-noise eff
In this paper, the solution of transient mass, momentum and energy balances in superfluid helium are discussed by means of a finite element algorithm. A simple linearization procedure is used for the non-linear pseudo-diffusion term in the energy balance arising because of the unique counterflow hea
The main limiting factor, among others, on how long an electrical machine can be operated continuously on load remains the temperature of the various circuit elements (electrical and magnetic) that constitute the machine. On the other hand, the maximum permissible temperature of the machine parts be