✦ LIBER ✦

Split design for mixer seal

Publisher: Elsevier Science
Year: 1999
Tongue: English
Weight: 133 KB
Volume: 1999
Category: Article
ISSN: 1350-4789
DOI: 10.1016/s1350-4789(99)90179-4

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Split seal for agitators and mixers

📂 Article 📅 1999 🏛 Elsevier Science 🌐 English ⚖ 122 KB

move relative to each other, a very small amount of PTFE is transferred to the surface of the shafi, which fills in microscopic surface irregularities and establishes an ideal running surface. This results in an efficient and durable sealing performance. The seal design allows controlled lip forces

Double seal in split design

📂 Article 📅 1999 🏛 Elsevier Science 🌐 English ⚖ 103 KB

Engineering design report on solving mix

Engineering design report on solving mixer seal problems

📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 283 KB

Dynamic sealing Engineering design report on solving mixer seal problems Durametallic UK has produced an engineering design report on solving mixer sealing problems, including both top and side entry types as typically used in the manufacture of pharmaceuticals, food supplements, polymers, solvents

Split seal for shafts

📂 Article 📅 2000 🏛 Elsevier Science 🌐 English ⚖ 173 KB

New seal introduced for mixers

📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 139 KB

Split seal for rapid installation

📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 292 KB

## Dynamic sealing between the rings of packing at the shaft. This void enables Anti-Keystone II Packing to consume up to 80% less power when compared to conventionally braided packings, according to the makers. Originally, this modification to the trapezoidal cross section was intended to add ma