𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Shape Optimization of Micro-Channel Heat Sink for Micro-Electronic Cooling

✍ Scribed by Husain, A.; Kwang-Yong Kim

Book ID
118026898
Publisher
IEEE
Year
2008
Tongue
English
Weight
726 KB
Volume
31
Category
Article
ISSN
1521-3331

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Heat transfer of gas–liquid mixture in m
Heat transfer of gas–liquid mixture in micro-channel heat sink
✍ G. Hetsroni; A. Mosyak; E. Pogrebnyak; Z. Segal πŸ“‚ Article πŸ“… 2009 πŸ› Elsevier Science 🌐 English βš– 842 KB

The main objective of the present investigation is to study heat transfer in parallel micro-channels of 0.1 mm in size. Comparison of the results of this study to the ones obtained for two-phase flow in ''conventional" size channels provides information on the complex phenomena associated with heat

Optimization of conduits' shape in micro
Optimization of conduits' shape in micro heat exchangers
✍ Haim H. Bau πŸ“‚ Article πŸ“… 1998 πŸ› Elsevier Science 🌐 English βš– 528 KB

An approximate theory is derived to compute the thermal resistances of flat plate micro heat exchangers whose surfaces are heated with uniform flux. It is demonstrated that the thermal resistance can be minimized by proper selection of uniform conduit geometry. Further reductions in the maximum heat

Critical heat flux for subcooled flow bo
Critical heat flux for subcooled flow boiling in micro-channel heat sinks
✍ Jaeseon Lee; Issam Mudawar πŸ“‚ Article πŸ“… 2009 πŸ› Elsevier Science 🌐 English βš– 1002 KB

Critical heat flux (CHF) was measured and examined with high-speed video for subcooled flow boiling in micro-channel heat sinks using HFE 7100 as working fluid. High subcooling was achieved by pre-cooling the working fluid using a secondary low-temperature refrigeration system. The high subcooling g