✦ LIBER ✦

Review of Factors that Affect Shrinkage of Molded Part in Injection Molding

✍ Scribed by Annicchiarico, Daniele; Alcock, Jeffrey R.

Book ID: 124161373
Publisher: Taylor and Francis Group
Year: 2014
Tongue: English
Weight: 934 KB
Volume: 29
Category: Article
ISSN: 1042-6914
DOI: 10.1080/10426914.2014.880467

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Handbook of Molded Part Shrinkage and Wa

Handbook of Molded Part Shrinkage and Warpage || Introduction to Injection Molding

✍ Fischer, Jerry M. 📂 Article 📅 2013 🏛 William Andrew 🌐 English ⚖ 926 KB

Influence of molding conditions on the s

Influence of molding conditions on the shrinkage and roundness of injection molded parts

✍ Mustafa Kurt; Yusuf Kaynak; Omer S. Kamber; Bilcen Mutlu; Barkin Bakir; Ugur Kok 📂 Article 📅 2009 🏛 Springer 🌐 English ⚖ 546 KB

Parameters affecting the full-shot moldi

Parameters affecting the full-shot molding of gas-assisted injection-molded parts

✍ Shih-Jung Liu; Kuang-Huei Chang 📂 Article 📅 2003 🏛 John Wiley and Sons 🌐 English ⚖ 484 KB 👁 2 views

Factors affecting the warpage of rotatio

Factors affecting the warpage of rotationally molded parts

✍ Shih-Jung Liu; Chung-Yuan Ho 📂 Article 📅 1999 🏛 John Wiley and Sons 🌐 English ⚖ 158 KB 👁 2 views

Rotational molding is one of the most important methods for the manufacture of hollow plastic products. However, there are several unsolved problems that confound the overall success of this technique. Part warpage caused by inappropriate mold design and processing conditions is one of them. An expe

A statistical analysis of the factors af

A statistical analysis of the factors affecting thermal debinding in powder injection molded parts

✍ A. O. Yakimov; T. W. Coyle 📂 Article 📅 2000 🏛 Springer 🌐 English ⚖ 360 KB

An Analytical Study of Constrained Shrin

An Analytical Study of Constrained Shrinkage of Injection Molded Semi-Crystalline Plastic Parts

✍ Azdast, T.; Behravesh, A. H. 📂 Article 📅 2008 🏛 Taylor and Francis Group 🌐 English ⚖ 338 KB