𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Quantitative determination of triethanolamine in cements

✍ Scribed by V.T. Yilmaz; N. Menek; M. Odabasoǧlu


Publisher
Elsevier Science
Year
1993
Tongue
English
Weight
305 KB
Volume
23
Category
Article
ISSN
0008-8846

No coin nor oath required. For personal study only.

✦ Synopsis


A new analysis method for the quantitative determination of triethanolamine (TEA) in the aqueous phase of cements was developed. TEA was converted into the TEA-Fe 3+ complex by treating it with IM NaOH and 10% Fe 3+ solutions. This method was based on the determination of the TEA-Fe 3+ complex by polarographic techniques. The TEA content in the aqueous phase of the tricalcium aluminate-gypsum system was analysed using the analysis method and the amount of TEA adsorbed was found to be ~l.5mg per g of the solid phase.


📜 SIMILAR VOLUMES


Analysis of triethanolamine in cement pa
✍ I. Jawed; M.T. McCall 📂 Article 📅 1977 🏛 Elsevier Science 🌐 English ⚖ 240 KB

Triethanolamine (TEA) in hardened cement paste has been analyzed by infrared spectrophotometry. The technique is sensitive for the qualitative detection of small amounts of TEA. However, the percent recovery is very much concentration dependent and, until the reproducibility of the method has been

Analysis of cement pastes for triethanol
✍ M.T. McCall; J. Mannone 📂 Article 📅 1975 🏛 Elsevier Science 🌐 English ⚖ 283 KB

This report describes our efforts to analyze cement pastes for triethanolamine. This analysis can be efficiently accomplished after short hydration times (ca. 3 min. ) by gas chromatography or infrared spectroscopy. Only trace amounts of the amine are detected, however, after 24 hours of hydration.

Rapid determination of fluorine in cemen
✍ I.S. Giles; M. Peisach 📂 Article 📅 1979 🏛 Elsevier Science 🌐 English ⚖ 338 KB

Prompt gamma rays from inelastic scattering and nuclear reactions induced by alpha particles have been used to determine fluorine in cements. The method is suitable for fluorine concentration of about 0.1% but is sensitive to parts per million. The precision of the method is determined by the homo