Abstract
To achieve a high level of purity in the purification of recombinant proteins for therapeutic or analytical application, it is necessary to use several chromatographic steps. There is a range of techniques available including anion and cation exchange, which can be carried out at different pHs, hydrophobic interaction chromatography, gel filtration and affinity chromatography. In the case of a complex mixture of partially unknown proteins or a clarified cell extract, there are many different routes one can take in order to choose the minimum and most efficient number of purification steps to achieve a desired level of purity (e.g. 98%, 99.5% or 99.9%).
This review shows how an initial 'proteomic' characterization of the complex mixture of target protein and protein contaminants can be used to select the most efficient chromatographic separation steps in order to achieve a specific level of purity with a minimum number of steps. The chosen methodology was implemented in a computerโ based Expert System. Two algorithms were developed, the first algorithm was used to select the most efficient purification method to separate a protein from its contaminants based on the physicochemical properties of the protein product and the protein contaminants and the second algorithm was used to predict the number and concentration of contaminants after each separation as well as protein product purity.
The application of the Expert System approach was experimentally tested and validated with a mixture of four proteins and the experimental validation was also carried out with a supernatant of Bacillus subtilis producing a recombinant ฮฒโ1,3โglucanase.
Once the type of chromatography is chosen, optimization of the operating conditions is essential. Chromatographic elution curves for a threeโprotein mixture (ฮฑโlactoalbumin, ovalbumin and ฮฒโlactoglobulin), carried out under different flow rates and ionic strength conditions, were simulated using two different mathematical models. These models were the Plate Model and the more fundamentally based Rate Model. Simulated elution curves were compared with experimental data not used for parameter identification. Deviation between experimental data and the simulated curves using the Plate Model was less than 0.0189 (absorbance units); a slightly higher deviation [0.0252 (absorbance units)] was obtained when the Rate Model was used. In order to optimize operating conditions, a cost function was built that included the effect of the different production stages, namely fermentation, purification and concentration. This cost function was also successfully used for the determination of the fraction of product to be collected (peak cutting) in chromatography. It can be used for protein products with different characteristics and qualities, such as purity and yield, by choosing the appropriate parameters. Copyright ยฉ 2008 John Wiley & Sons, Ltd.