✦ LIBER ✦

Programs for two-sided printed circuit board design

✍ Scribed by R.C. Rosa; T.P. Lucio

Publisher: Elsevier Science
Year: 1979
Tongue: English
Weight: 619 KB
Volume: 11
Category: Article
ISSN: 0010-4485
DOI: 10.1016/0010-4485(79)90075-7

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Printed circuit board design

📂 Article 📅 1973 🏛 Elsevier Science 🌐 English ⚖ 133 KB

A document No.2764, describing the c.a.d, of printed circuit boards has been issued by the Royal Radar Establishment, Malvern. The authors, D. A. H. Brown and A. H. James, first used Lee's algorithm for routeing. Advantages of this method are that if a path exists through the maze, the algorithm wil

Several releases for printed circuit boa

Several releases for printed circuit board design

📂 Article 📅 1988 🏛 Elsevier Science 🌐 English ⚖ 103 KB

CAD package for design of printed circui

CAD package for design of printed circuit boards

📂 Article 📅 1987 🏛 Elsevier Science 🌐 English ⚖ 111 KB

Modeling double-side printed meander-lin

Modeling double-side printed meander-line inductors on printed circuit boards

✍ J. E. Acuña; J. L. Rodriguez; F. Obelleiro 📂 Article 📅 2003 🏛 John Wiley and Sons 🌐 English ⚖ 208 KB

A lumped element model for a double-side printed meander-line inductor with closed-form expressions for the electrical model parameters L, C, R l , and R c is presented. These structures are cheaper than coils and need less area per unit of inductance than single-side printed meander-line inductors.

Design of meander line inductors on prin

Design of meander line inductors on printed circuit boards

✍ J. E. Acuña; J. L. Rodriguez; F. Obelleiro 📂 Article 📅 2001 🏛 John Wiley and Sons 🌐 English ⚖ 276 KB

A partial-element circuit model for meander line inductors printed on circuit boards is proposed and its relation with the physical layout is derived. A procedure for the design is presented allowing to obtain inductances between 8 and 50 nH in the range from 30 to 1000 MHz with a 5% mean error.

Modeling and design of milled microwave

Modeling and design of milled microwave printed circuit boards

✍ Antonije R. Djordjević; Dragan I. Olćan; Alenka G. Zajić 📂 Article 📅 2010 🏛 John Wiley and Sons 🌐 English ⚖ 757 KB

## Abstract This article investigates the influence of milling process on properties of printed microwave circuits. Furthermore, design guidelines are proposed for optimizing the milling process by leaving large unmilled copper surfaces on the board without deteriorating circuit performance. The pr