Processing and dielectric properties of Bi-doped Sr(Ti0.95Zr0.05)O3 ceramics
โ Scribed by Zongyang Shen; Hanxing Liu; Zhonghua Yao; Zhaohui Wu; Minghe Cao; Dabing Luo
- Publisher
- Elsevier Science
- Year
- 2008
- Tongue
- English
- Weight
- 523 KB
- Volume
- 197
- Category
- Article
- ISSN
- 0924-0136
No coin nor oath required. For personal study only.
โฆ Synopsis
This paper investigates Bi-doped Sr(Ti 0.95 Zr 0.05 )O 3 ceramics prepared by solid state method.
Both the effect of grinding time on particle size distribution of ceramic powders and the effect of sintering temperature on microstructure and dielectric properties of ceramics are studied. The samples are characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM). Apparent density measurements and their dielectric properties are established at room temperature. XRD analysis shows that the ceramics kept cubic perovskite structure with the grain size about 1-2 m observed by SEM image. The relative density of the obtained materials reaches higher than 94% and they exhibit properties as follows: dielectric constant ฮต r > 500 and dielectric loss tanฤฑ < 6.0 ร 10 -3 under 1 MHz and the breakdown strength E b > 10 kV/mm.
๐ SIMILAR VOLUMES
## Abstract The ferroelectricโtoโferroelectric phase transition between the high temperature (FE~RH~) and the low temperature (FE~RL~) rhombohedral phases in a Nbโdoped Pb(Zr~0.95~Ti~0.05~)O~3~ ceramic was investigated with transmission electron microscopy (TEM). Both bright field images and electr
Ca(Zr 0.05 Ti 0.95 )O 3 (CZT) thin films were grown on Pt(1 1 1)/Ti/SiO 2 /Si(1 0 0) substrates by the soft chemical method. The films were deposited from spin-coating technique and annealed at 928 K for 4 h under oxygen atmosphere. CZT films present orthorhombic structure with a crack free and gran
The (micro)structural and electrical properties of undoped and Er 3+ -doped BaTi 0.85 Zr 0.15 O 3 ceramics were studied in this work for both nominal Ba 2+ and Ti 4+ substitution formulations. The ceramics were produced from solid-state reaction and sintered at 1400 โข C for 3 h. For those materials