✦ LIBER ✦

Pressure distribution in molding GRP parts of complex shape

✍ Scribed by G. G. Portnov

Publisher: Springer US
Year: 1967
Tongue: English
Weight: 446 KB
Volume: 1
Category: Article
ISSN: 1573-8922
DOI: 10.1007/bf00858899

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Automated fabrication of complex molded

Automated fabrication of complex molded parts using Mold Shape Deposition Manufacturing

✍ A.G Cooper; S Kang; J.W Kietzman; F.B Prinz; J.L Lombardi; L.E Weiss 📂 Article 📅 1999 🏛 Elsevier Science ⚖ 739 KB

## Ž . Mold Shape Deposition Manufacturing Mold SDM is a solid freeform fabrication technique for producing complex shaped fugitive wax molds. A variety of castable polymer and ceramic materials have been used to make parts from these molds. This paper describes the Mold SDM method and an automate

Analogy of temperature distribution with

Analogy of temperature distribution with density distribution and powder cross-flow in the pressing of parts of complex shape. I. Fundamental equation

✍ I. D. Radomysel'skii; M. B. Shtern; A. K. Grabchak 📂 Article 📅 1985 🏛 Springer 🌐 English ⚖ 254 KB

Analogy of temperature distribution with

Analogy of temperature distribution with density distribution and powder cross-flow in the pressing of parts of complex shape II. Effect of mode of pressing on density distribution

✍ I. D. Radomysel'skii; M. B. Shtern; A. K. Grabchak 📂 Article 📅 1985 🏛 Springer 🌐 English ⚖ 369 KB

Development of density distributions in

Development of density distributions in injection molded amorphous engineering plastics. Part I

✍ Jeong S. Yu; Marilu Lim; Dilhan M. Kalyon 📂 Article 📅 1991 🏛 Society for Plastic Engineers 🌐 English ⚖ 676 KB

Development of density distributions in

Development of density distributions in injection molded amorphous engineering plastics. Part II

✍ Jeong S. Yu; Dilhan M. Kalyon 📂 Article 📅 1991 🏛 Society for Plastic Engineers 🌐 English ⚖ 712 KB

Optimum shape design of die and preform

Optimum shape design of die and preform for improved hardness distribution in cold forged parts

✍ Haluk Tumer; Fazıl O. Sonmez 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 908 KB

Hardness of a cold formed part increases due to plastic deformation induced during the forming process. Hardness affects forgability of the part as well as its mechanical performance in use. In this study, a method was proposed to optimize the shape of preform and die to minimize variation in hardne