✦ LIBER ✦

Development of density distributions in injection molded amorphous engineering plastics. Part I

✍ Scribed by Jeong S. Yu; Marilu Lim; Dilhan M. Kalyon

Publisher: Society for Plastic Engineers
Year: 1991
Tongue: English
Weight: 676 KB
Volume: 31
Category: Article
ISSN: 0032-3888
DOI: 10.1002/pen.760310302

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Development of density distributions in

Development of density distributions in injection molded amorphous engineering plastics. Part II

✍ Jeong S. Yu; Dilhan M. Kalyon 📂 Article 📅 1991 🏛 Society for Plastic Engineers 🌐 English ⚖ 712 KB

Simulation of microstructure development

Simulation of microstructure development in injection molding of engineering plastics

✍ Jeong S. Yu; Alan H. Wagner; Dilhan M. Kalyon 📂 Article 📅 1992 🏛 John Wiley and Sons 🌐 English ⚖ 829 KB

Mathematical models were developed to predict the various microstructural properties, including birefringence, residual stress, and density distributions, in the freely quenched compression molded samples as well as in the injection molded samples. To model the birefringence distribution in the inje

Expert systems in engineering design: an

Expert systems in engineering design: an application for injection molding of plastic parts

✍ Sally Steadman; Kynric M. Pell 📂 Article 📅 1995 🏛 Springer US 🌐 English ⚖ 650 KB

Effect of process conditions on birefrin

Effect of process conditions on birefringence development in injection-molded parts. I. Numerical analysis

✍ Shia Chung Chen; Yung Cheng Chen 📂 Article 📅 1995 🏛 John Wiley and Sons 🌐 English ⚖ 901 KB

Temperature measurements of polymer melt

Temperature measurements of polymer melts in the heating barrel during injection molding. Part I. Temperature distribution along the screw axis in the reservoir

✍ Osamu Amano; Shirou Utsugi 📂 Article 📅 1988 🏛 Society for Plastic Engineers 🌐 English ⚖ 670 KB