✦ LIBER ✦

Potential cost savings in a plastics injection moulding shop

✍ Scribed by D.P. Howe; R. McIlhagger; P. McDonagh

Publisher: Elsevier Science
Year: 1991
Tongue: English
Weight: 381 KB
Volume: 26
Category: Article
ISSN: 0924-0136
DOI: 10.1016/0924-0136(91)90137-4

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A simple model for stress relaxation in

A simple model for stress relaxation in injection moulded plastics with an internal stress distribution

✍ J Kubát; M Rigdahl 📂 Article 📅 1975 🏛 Elsevier Science ⚖ 628 KB

The cost of rear-end collisions in Denma

The cost of rear-end collisions in Denmark and the potential savings from a high, center-mounted auxiliary brake light

✍ Ronald L. Somers; Anni Hansen 📂 Article 📅 1984 🏛 Elsevier Science 🌐 English ⚖ 882 KB

The objective of this study was to determine the cost of rear-end collisions in Denmark, and to define the potential financial benefits of a high, center-mounted auxiliary brake light for automobiles. The study was limited to passenger cars struck from behind. The annual cost of two different preven

98/03986 Potential for savings in compli

98/03986 Potential for savings in compliance costs for reducing ground-level ozone possible by instituting seasonal versus annual nitric oxide emission limits. A case study for coal-fired boilers in the state of Maryland

📂 Article 📅 1998 🏛 Elsevier Science ⚖ 225 KB

## 9WO3983 New materials in steam boiler construction Scheffknecht, G. and Kather, A. Brennst.-Waerme-Krafl, 1997,49, (11/12), 62-67. (In German) The use of new steels in conventional coal-fired steam power stations in order to increase the steam conditions with the consequent reduction of CO2 emi