𝔖 Bobbio Scriptorium

✦ LIBER ✦

On interval-subgradient and no-good cuts

✍ Scribed by Claudia D’Ambrosio; Antonio Frangioni; Leo Liberti; Andrea Lodi

Publisher: Elsevier Science
Year: 2010
Tongue: English
Weight: 308 KB
Volume: 38
Category: Article
ISSN: 0167-6377
DOI: 10.1016/j.orl.2010.05.010

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Confidence intervals for the ratio of tw

Confidence intervals for the ratio of two poisson means and poisson predictor intervals : W. Nelson. IEEE Trans. on Reliab.R-19, No. 2, May (1970), p. 42

📂 Article 📅 1971 🏛 Elsevier Science 🌐 English ⚖ 59 KB

On a criterion of cutting velocity in me

On a criterion of cutting velocity in metal machining : F. F. Ling and Edward Saibel. ASLE transactions, v. 1, no. 1, Apr. 1958, p. 124–130

📂 Article 📅 1959 🏛 Elsevier Science 🌐 English ⚖ 136 KB

Study on shave-tuning. Cutting with incl

Study on shave-tuning. Cutting with inclined straight-edged tool : Masao Kubota, Tamehiro Kotorii, and Minori Kanai. Journal of Mechanical Laboratory (Japan), v. 3, no. 1, 1957, p. 24–32

📂 Article 📅 1958 🏛 Elsevier Science 🌐 English ⚖ 124 KB

Cutting of thin carbon films with a CO2-

Cutting of thin carbon films with a CO2-gas laser—I. Theoretical considerations and experiments on flat plates : J. G. Siekman, Microelectron. & Reliab. 8, No. 2, May (1969), p. 87

📂 Article 📅 1970 🏛 Elsevier Science 🌐 English ⚖ 101 KB

Experimental study on the combined influ

Experimental study on the combined influence of the sharpening angle of the tool and of the cutting speed on the modalities of chip formation : E. Eugene. Microtecnic (English Ed.), v. 11. no. 5. 1957. P. 223–230

📂 Article 📅 1958 🏛 Elsevier Science 🌐 English ⚖ 95 KB

Influence of the machined diameter on th

Influence of the machined diameter on the behaviour of cutting tools during turning operations : F. Eugène, B. Jugue, and R. Parran. Microtecnic (English ed.), v. 11, no. 4, 1957, p. 147–150

📂 Article 📅 1958 🏛 Elsevier Science 🌐 English ⚖ 69 KB