✦ LIBER ✦

Numerical analysis of mixed mode I and Mode II fracture propagation

✍ Scribed by B. Shen; O. Stephansson

Publisher: Elsevier Science
Year: 1993
Tongue: English
Weight: 651 KB
Volume: 30
Category: Article
ISSN: 0148-9062
DOI: 10.1016/0148-9062(93)90037-e

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Mixed-mode-I/II fracture of polytetraflu

Mixed-mode-I/II fracture of polytetrafluoroethylene

✍ Eric N. Brown; Philip J. Rae; Cheng Liu 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 971 KB

Fracture tests for ceramics under mode-I

Fracture tests for ceramics under mode-I, mode-II and mixed-mode loading

✍ T. Fett; G. Gerteisen; S. Hahnenberger; G. Martin; D. Munz 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 594 KB

Mixed-mode I/II wood fracture characteri

Mixed-mode I/II wood fracture characterization using the mixed-mode bending test

✍ M.F.S.F. de Moura; J.M.Q. Oliveira; J.J.L. Morais; J. Xavier 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 504 KB

In this work fracture characterization of wood under mixed-mode I/II loading is addressed. The mixed-mode bending test is used owing to its aptitude for easier alteration of mode ratio. Experimental tests were performed covering a wide range of mode ratios in order to obtain a mixed-mode fracture cr

Mixed mode crack propagation and fractur

Mixed mode crack propagation and fracture in concrete

✍ S.E. Swartz; N.M. Taha 📂 Article 📅 1990 🏛 Elsevier Science 🌐 English ⚖ 603 KB

## Ahatract-Results of experiments using the Iosipescu test specimen in which axial compression has been introduced in addition to the shearing loads are reported here. Different crack paths and fracture modes were obtained depending on the presence or absence of axial compression. Computer model

Determination of fracture zone propertie

Determination of fracture zone properties in mixed mode I and II

✍ Monouchehr Hassanzadeh 📂 Article 📅 1990 🏛 Elsevier Science 🌐 English ⚖ 78 KB

Abatraet-Notched beams of saturated concrete were tested, according to RILEM procedure, at temperatures ranging from 20 to -170°C. A model recently proposed by the authors, the Perturbed Ligament Model, was used to obtain size-independent Gr values. Results show that the perturbation lengths are tem

Determination of fracture zone propertie

Determination of fracture zone properties in mixed mode I and II

✍ Manouchehr Hassanzadeh 📂 Article 📅 1990 🏛 Elsevier Science 🌐 English ⚖ 843 KB

A test equipment for the measurement of material properties within a damage zone subject to combined tension and shear deformations is described. Some results have been presented and discussed concerning the damage zone behaviour under such conditions.