✦ LIBER ✦

N-type amorphous silicon-based bilayers for cost-effective thin-film silicon photovoltaic devices

✍ Scribed by Myong, Seung Yeop; Jeon, La Sun

Book ID: 122237093
Publisher: Elsevier Science
Year: 2014
Tongue: English
Weight: 714 KB
Volume: 14
Category: Article
ISSN: 1567-1739
DOI: 10.1016/j.cap.2013.10.021

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Low temperature crystallization of amorp

Low temperature crystallization of amorphous silicon carbide thin films for p–n junction devices fabrication

✍ Maruf Hossain; Minseong Yun; Venumadhav Korampally; Shubhra Gangopadhyay 📂 Article 📅 2007 🏛 Springer US 🌐 English ⚖ 273 KB

Amorphous silicon–carbon based nano-scal

Amorphous silicon–carbon based nano-scale thin film anode materials for lithium ion batteries

✍ Moni Kanchan Datta; Jeffrey Maranchi; Sung Jae Chung; Rigved Epur; Karan Kadakia 📂 Article 📅 2011 🏛 Elsevier Science 🌐 English ⚖ 985 KB

The buffering effect of carbon on the structural stability of amorphous silicon films, used as an anode for lithium ion rechargeable batteries, has been studied during long term discharge/charge cycles. To this extent, the electrochemical performance of a prototype material consisting of amorphous S

A carbonaceous thin film made by CVD and

A carbonaceous thin film made by CVD and its application for a carbon/n-type silicon (C/n-Si) photovoltaic cell

✍ H.A. Yu; T. Kaneko; S. Otani; Y. Sasaki; S. Yoshimura 📂 Article 📅 1998 🏛 Elsevier Science 🌐 English ⚖ 668 KB

A carbonaceous thin film was made by CVD of 2,5-dimethyl-p-benzoquinone at temperatures between 500 and 1000°C and its structural and electronic properties have been studied. The carbonaceous thin film made at 500°C has a energy bandgap of 0.25-0.3 eV and a positive Hall coefficient of 5 x 1O-5 m3 C

98/02215 A carbonaceous thin film made b

98/02215 A carbonaceous thin film made by CVD and its application for a carbon/n-type silicon (C/n-Si) photovoltaic cell : Yu, H. A. et al. Carbon, 1998, 36, (1), 137–143

📂 Article 📅 1998 🏛 Elsevier Science ⚖ 205 KB

A study into the effect of hydrogen sulfide on the steam reforming of methane. Methane is the most difficult component to convert by steam reforming in a mixture of hydrocarbons, which is produced in biomass gasification. Two catalysts were subjected to hydrogen sulfide levels up to 300 ppm so as to