✦ LIBER ✦

Modelling the cutting edge radius size effect for force prediction in micro milling

✍ Scribed by G. Bissacco; H.N. Hansen; J. Slunsky

Book ID: 108094949
Publisher: International Academy for Production Engineering
Year: 2008
Tongue: English
Weight: 493 KB
Volume: 57
Category: Article
ISSN: 0007-8506
DOI: 10.1016/j.cirp.2008.03.085

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Tool edge radius effect on cutting tempe

Tool edge radius effect on cutting temperature in micro-end-milling process

✍ Kai Yang; Ying-chun Liang; Kang-ning Zheng; Qing-shun Bai; Wan-qun Chen 📂 Article 📅 2010 🏛 Springer 🌐 English ⚖ 716 KB

Cutting force model considering tool edg

Cutting force model considering tool edge geometry for micro end milling process

✍ Ik Soo Kang; Jeong Suk Kim; Yong Wie Seo 📂 Article 📅 2008 🏛 Springer-Verlag 🌐 English ⚖ 548 KB

The prediction of cutting forces in the

The prediction of cutting forces in the ball-end milling process—II. Cut geometry analysis and model verification

✍ Hsi-Yung Feng; Chia-Hsiang Menq 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 409 KB

The prediction of cutting forces in the

The prediction of cutting forces in the ball-end milling process—I. Model formulation and model building procedure

✍ Hsi-Yung Feng; Chia-Hsiang Menq 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 728 KB

This paper presents a model for the prediction of cutting forces in the ball-end milling process. The steps used in developing the force model are based on the mechanistic principles of metal cutting. The cutting forces are calculated on the basis of the engaged cut geometry, the undeformed chip thi

Effect of the tokamak size in edge trans

Effect of the tokamak size in edge transport modelling and implications for DEMO

✍ H.D. Pacher; A.S. Kukushkin; G.W. Pacher; G. Janeschitz; D. Coster; V. Kotov; D. 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 203 KB