✦ LIBER ✦

Modeling thermal exposure effects on fatigue of gamma titanium aluminides

✍ Scribed by P.K Wright; A.H Rosenberger

Book ID: 108467346
Publisher: Elsevier Science
Year: 2002
Tongue: English
Weight: 202 KB
Volume: 329-331
Category: Article
ISSN: 0921-5093
DOI: 10.1016/s0921-5093(01)01556-8

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Plastic deformation depth modeling on gr

Plastic deformation depth modeling on grinding of gamma Titanium Aluminides

✍ Gregorio R. Murtagian; Rogelio L. Hecker; Steven Y. Liang; Steven Danyluk 📂 Article 📅 2009 🏛 Springer 🌐 English ⚖ 372 KB

Effects of stress concentrations on the

Effects of stress concentrations on the fatigue life of a gamma-based titanium aluminide

✍ S.J. Trail; P. Bowen 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 1002 KB

Investigation on the oxidation behaviour

Investigation on the oxidation behaviour of gamma titanium aluminides coated with thermal barrier coatings

✍ R. Braun; M. Fröhlich; A. Ebach-Stahl; C. Leyens 📂 Article 📅 2008 🏛 John Wiley and Sons 🌐 German ⚖ 677 KB

## Abstract In the present study, the applicability of thermal barrier coatings (TBCs) on γ‐TiAl alloys was investigated. Two alloys with the chemical compositions of Ti‐45Al‐8Nb‐0.2B‐0.15C and Ti‐45Al‐1Cr‐6Nb‐0.4W‐0.2B‐0.5C‐0.2Si were used. Before TBC deposition, the specimens were pre‐oxidised in

Effect of stress ratio on fatigue crack

Effect of stress ratio on fatigue crack growth in a titanium aluminide alloy

✍ B. K. Parida; T. Nicholas 📂 Article 📅 1991 🏛 Springer Netherlands 🌐 English ⚖ 168 KB

Recent studies on fatigue crack growth of an alpha 2 titanium aluminide,Ti-24A1-11Nb intermetallic at room temperature [1-3] indicate a strong dependence of fatigue crack growth rate on the stress ratio, R (ratio of minimum stress to maximum stress) . Figure shows the variation of da/dN with stress

Effect of microstructures on the hydroge

Effect of microstructures on the hydrogen attack to gamma titanium aluminide at low temperature

✍ E. Hamzah; K. Suardi; A. Ourdjini 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 713 KB

The effects of machined workpiece surfac

The effects of machined workpiece surface integrity on the fatigue life of γ-titanium aluminide

✍ A.R.C Sharman; D.K Aspinwall; R.C Dewes; D Clifton; P Bowen 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 242 KB

Tension-tension tests on turned, electro-chemical machined (ECM) and electro-discharge textured (EDT) specimens made from Ti-45Al-2Nb-2Mn+0.8 vol% TiB 2 alloy, showed the turned specimens to have a higher fatigue strength ෂ475 MPa. It is likely that this was due to the presence of highly compressive