✦ LIBER ✦

Modeling the packing stage in injection molding of thermoplastics

✍ Scribed by D. Huilier; C. Lenfant; J. Terrisse; R. Deterre

Publisher: Society for Plastic Engineers
Year: 1988
Tongue: English
Weight: 656 KB
Volume: 28
Category: Article
ISSN: 0032-3888
DOI: 10.1002/pen.760282410

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Pressure losses in the packing stage of

Pressure losses in the packing stage of injection molding

✍ M. W. Darlington; A. J. Scott; A. C. Smith 📂 Article 📅 1986 🏛 Society for Plastic Engineers 🌐 English ⚖ 774 KB

Analysis of the packing stage in injecti

Analysis of the packing stage in injection molding of disk cavities

✍ Tai-Shung Chung; Yoshiaki Ide 📂 Article 📅 1983 🏛 John Wiley and Sons 🌐 English ⚖ 209 KB 👁 1 views

Pressure build-up during the packing sta

Pressure build-up during the packing stage of injection molding

✍ Tai-Shung Chung 📂 Article 📅 1985 🏛 Society for Plastic Engineers 🌐 English ⚖ 442 KB

## Abstract A thorough study of an isothermal fluid motion within the mold cavity during the packing stage is presented. The fluid is considered Newtonian, and its compressible behavior is assumed to obey the Spencer‐Gilmore equation of state. Mathematical results indicate that the pressure built u

On the packing–holding flow in the injec

On the packing–holding flow in the injection molding of thermoplastic polymers

✍ G. Titomanlio; S. Piccarolo; G. Levati 📂 Article 📅 1988 🏛 John Wiley and Sons 🌐 English ⚖ 647 KB

General consequences of the packing phas

General consequences of the packing phase in injection molding

✍ J. Greener 📂 Article 📅 1986 🏛 Society for Plastic Engineers 🌐 English ⚖ 708 KB

Dynamics and control of pressure in the

Dynamics and control of pressure in the injection molding of thermoplastics

✍ M. R. Kamal; W. I. Patterson; N. Conley; D. Abu Fara; G. Lohfink 📂 Article 📅 1987 🏛 Society for Plastic Engineers 🌐 English ⚖ 614 KB