## Abstract Size reduction of microwave and millimeter‐wave (mm‐wave) passive circuits incorporating a defective uniplanar compact photonic bandgap (UC‐PBG) slow‐wave structure is investigated. Benefited from the multilayer mental technology of the standard 0.18‐μm CMOS process, thin film microstri
Millimeter-wave low-loss transmission lines and resonators in standard 0.18-μm CMOS technology
✍ Scribed by Shui-Yang Lin; Li-Wu Yang; Xiao-Wei Sun
- Publisher
- John Wiley and Sons
- Year
- 2008
- Tongue
- English
- Weight
- 213 KB
- Volume
- 50
- Category
- Article
- ISSN
- 0895-2477
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
Design methodologies of CMOS transmission lines (T‐lines) and resonators at millimeter‐wave frequencies are presented. Three different T‐lines including thin film microstrip line, coplanar waveguide, coplanar waveguide with ground, are designed and fabricated in standard 0.18‐μm CMOS technology. After on‐wafer testing to 40 GHz and SLOT de‐embedding calibration, their S‐parameters are extracted and analyzed. To achieve a small size, meandering quarter‐wavelength line resonator and stepped impedance resonator resonating near 30 GHz are designed, with their Q‐factor of 12 and 10.5, respectively. A good agreement between the predicted and measured results has been observed up to 40 GHz. © 2008 Wiley Periodicals, Inc. Microwave Opt Technol Lett 50: 1579–1582, 2008; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.23424
📜 SIMILAR VOLUMES
## Abstract Slow wave coplanar transmission lines (S‐CPW) based on conventional coplanar CPW transmission lines with a floating patterned ground plane are good candidates for the integration of distributed RF circuits for front‐end modules. They offer high quality factors when compared to conventio
## Abstract This article presents two types of switches which are fabricated in 0.13‐μm standard CMOS process characterized up to 50 GHz. The first is the conventional series NMOS switch with an optimum gate width which is adjusted by measuring various sized devices. The second is a new active type
## Abstract This article describes a monolithic receiver front end comprising a low‐noise amplifier (LNA), a mixer, an intermediate‐frequency (IF) amplifier, and an IF filter implemented in a standard 0.18 μm CMOS technology.Current‐reused technique is used in the LNA to reduce power dissipation. C