𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Microwave evaluation of the conductive filler particles of carbon black-rubber composites

✍ Scribed by J. H. Kaiser


Publisher
Springer
Year
1993
Tongue
English
Weight
391 KB
Volume
56
Category
Article
ISSN
1432-0630

No coin nor oath required. For personal study only.


📜 SIMILAR VOLUMES


Electrical conductivity of carbon black
✍ Sau, K. P. ;Khastgir, D. ;Chaki, T. K. 📂 Article 📅 1998 🏛 John Wiley and Sons 🌐 English ⚖ 76 KB 👁 2 views

Electrically conductive silicone rubber composites have been prepared through incorporation of conductive acetylene black and short carbon fibre (SCF). The percolation limit for the attainment of high conductivity is found to be relatively less for silicone rubber based composites compared to EPDM o

Electromagnetic interference shielding e
✍ N. C. Das; T. K. Chaki; D. Khastgir; A. Chakraborty 📂 Article 📅 2001 🏛 John Wiley and Sons 🌐 English ⚖ 945 KB

## Abstract Conductive rubber‐based composites were derived from EVA, EPDM, and 50/50 EVA/EPDM blend filled with carbon black and short carbon fiber (SCF). The electromagnetic interference (EMI) shielding effectiveness and return loss were studied. The measurements of shielding effectiveness (SE) o

Effect of some service conditions on the
✍ G. T. Mohanraj; T. K. Chaki; A. Chakraborty; D. Khastgir 📂 Article 📅 2004 🏛 John Wiley and Sons 🌐 English ⚖ 129 KB 👁 2 views

## Abstract Conductive polymer composites were prepared using vulcanized styrene–butadiene rubber as a matrix and conductive carbon black as a filler. The filler loading was varied from 10 to 60 phr. The volume resistivity was measured against the loading of the carbon black to verify the percolati

Influence of filler–rubber interactions
✍ J. Léopoldès; C. Barrès; J. L. Leblanc; P. Georget 📂 Article 📅 2003 🏛 John Wiley and Sons 🌐 English ⚖ 213 KB 👁 2 views

## Abstract The specific role of filler–rubber interactions in dynamic properties was investigated. Natural rubber compounds, filled with N330 carbon black, were used, and the filler surface was modified through a gas treatment in the solid phase. The effects of this filler surface treatment on the