𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Microstructure and Mechanical Properties of Low-Pressure Cold-Sprayed (LPCS) Coatings

✍ Scribed by Heli Koivuluoto; Juha Lagerbom; Mikko Kylmälahti; Petri Vuoristo

Book ID
107462186
Publisher
Springer US
Year
2008
Tongue
English
Weight
499 KB
Volume
17
Category
Article
ISSN
1059-9630

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Microstructure and Mechanical Properties
Microstructure and Mechanical Properties of Low-Pressure Cold-Sprayed (LPCS) Coatings
✍ Heli Koivuluoto; Juha Lagerbom; Mikko Kylmälahti; Petri Vuoristo 📂 Article 📅 2008 🏛 Springer US 🌐 English ⚖ 499 KB

In low-pressure cold spraying, compressed air is used as a process gas. The most important process parameters are temperature and pressure. In the Low-Pressure Cold Spraying (LPCS) system in this study, the maximum preheating temperature is 650 °C and pressure is 9 bar. Powders used in LPCS process

Microstructure, mechanical properties, a
Microstructure, mechanical properties, and adhesion in IN625 air plasma sprayed coatings
✍ Thomas Gnaeupel-Herold; Henry J. Prask; John Barker; Frank S. Biancaniello; Rodn 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 622 KB

The effects of feed stock particle size on the microstructure and the mechanical properties of IN625 air plasma sprayed coatings were investigated. It was found that the porosity increases with the particles size while the oxide content rises with decreasing particle size. Because of the lower veloc