𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Mechanical Property Mapping of Cold Sprayed Ti Splats and Coatings

✍ Scribed by Dina Goldbaum; Richard R. Chromik; Stephen Yue; Eric Irissou; Jean-Gabriel Legoux

Book ID
107462427
Publisher
Springer US
Year
2010
Tongue
English
Weight
965 KB
Volume
20
Category
Article
ISSN
1059-9630

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Residual stress and thermo-mechanical pr
Residual stress and thermo-mechanical properties of cold spray metal coatings
✍ V. Luzin; K. Spencer; M.-X. Zhang πŸ“‚ Article πŸ“… 2011 πŸ› Elsevier Science 🌐 English βš– 632 KB

The residual stress profiles in Cu and Al coatings cold sprayed using kinetic metallization have been studied using neutron diffraction. To interpret results and to describe them quantitatively, the measured profiles were fit to Tsui and Clyne's progressive coating deposition model, which demonstrat

Microstructure and Mechanical Properties
Microstructure and Mechanical Properties of Low-Pressure Cold-Sprayed (LPCS) Coatings
✍ Heli Koivuluoto; Juha Lagerbom; Mikko KylmΓ€lahti; Petri Vuoristo πŸ“‚ Article πŸ“… 2008 πŸ› Springer US 🌐 English βš– 499 KB

In low-pressure cold spraying, compressed air is used as a process gas. The most important process parameters are temperature and pressure. In the Low-Pressure Cold Spraying (LPCS) system in this study, the maximum preheating temperature is 650 Β°C and pressure is 9 bar. Powders used in LPCS process