✦ LIBER ✦

Microstructural characterization of squeeze-cast Al–8Fe–1.4V–8Si

✍ Scribed by M. Arhami; F. Sarioglu; A. Kalkanli; M. Hashemipour

Publisher: Elsevier Science
Year: 2008
Tongue: English
Weight: 999 KB
Volume: 485
Category: Article
ISSN: 0921-5093
DOI: 10.1016/j.msea.2007.07.065

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Microstructural and compositional charac

Microstructural and compositional characterization of TiW/Al(0.8%Si)/TiW/PtSi/(100)Si

✍ A. Ashkenazi; Y. Komen; I. Lerner 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 861 KB

Aluminium borate whisker reinforced Al-8

Aluminium borate whisker reinforced Al-8.5 Fe-1.3 V-1.7 Si composite

✍ Z. Y. Ma; J. Pan; X. G. Ning; J. H. Li; X. Y. Lu; J. Bi 📂 Article 📅 1994 🏛 Springer 🌐 English ⚖ 496 KB

Ambient temperature mechanical propertie

Ambient temperature mechanical properties of Al–8.5Fe–1.3V–1.7Si/SiCP composite

✍ Z.H. Chen; Y.Q. He; H.G. Yan; Z.G. Chen; X.J. Yin; G. Chen 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 961 KB

Ambient temperature mechanical properties of Al-8.5Fe-1.3V-1.7Si/15 vol.%SiC P composite sheet prepared by a spray deposition (SD)-rolling process were investigated. The experimental results show that the densification method of the as-deposited preforms has an obvious effect on the mechanical prope

Effect of Ni–Mg on the microstructure an

Effect of Ni–Mg on the microstructure and properties of Al–(4–5)Fe–1V–1Si alloys

✍ B.N. Pathak; Arvind Kumar; K.L. Sahoo; P. Talukdar 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 574 KB

Undercooling and supersaturation of allo

Undercooling and supersaturation of alloying elements in rapidly solidified Al-8.5% Fe-1.2% V-1.7% Si alloy

✍ S. Hariprasad; S. M. L. Sastry; K. L. Jerina 📂 Article 📅 1996 🏛 Springer 🌐 English ⚖ 1016 KB

Dispersion-strengthened AI-8.5% Fe-1.2% V-1.7% Si alloy was produced by inert gas atomization and atomized melt deposition processes. Differential scanning calorimetry was used to estimate the extent of undercooling in the alloy powders as a function of powder size and in the atomized melt-deposited

Creep behavior of fine grained Cu-2.8 Al

Creep behavior of fine grained Cu-2.8 Al-1.8 Si-0.4 Co alloy

✍ A. Arieli; T. Kainuma; A.K. Mukherjee 📂 Article 📅 1982 🏛 Elsevier Science ⚖ 919 KB

The elevated temperature creep properties of a fine grained copper alloy (CDA 638) was investigated between 673 and 798 K at strain rates ranging from lo-' s-' to 2 x lo-\* s-'. The mechanical data were analyzed in order to establish the stress, temperature, and grain size dependence of the strain r