✦ LIBER ✦

Microstructural characteristics and mechanical properties of Al–2.5 wt.% Li–1.2 wt.% Cu–xMg alloys

✍ Scribed by Jeong-Min Kim; Ki-Dug Seong; Joong-Hwan Jun; Keesam Shin; Ki-Tae Kim; Woon-Jae Jung

Book ID: 116601158
Publisher: Elsevier Science
Year: 2007
Tongue: English
Weight: 521 KB
Volume: 434-435
Category: Article
ISSN: 0925-8388
DOI: 10.1016/j.jallcom.2006.08.230

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Microstructure and mechanical properties

Microstructure and mechanical properties of spray co-deposited Al–8.9 wt.% Si–3.2 wt.% Cu–0.9 wt.% Fe + (Al–3 wt.% Mn–4 wt.% Si)p composite

✍ L.A. Bereta; C.F. Ferrarini; W.J. Botta F; C.S. Kiminami; C. Bolfarini 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 646 KB

Precipitation kinetics in Ag–2 wt%

Precipitation kinetics in Ag–2 wt% Cu and Ag–2 wt% Cu–0.5 wt% In alloys during transformation

✍ R.H. Nada 📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 284 KB

The effect of quenching rate on the stress-strain characteristics of Ag-2 wt% Cu and Ag-2 wt% Cu-0.5 wt% In alloys was investigated in the temperature range from 723 K to 923 K. The work-hardening parameters s y , s f , and w, were found to decrease with increasing aging temperature exhibiting maxim

The variation of tensile characteristics

The variation of tensile characteristics of Al–2 wt.%Ag and Al–2 wt.%Ag–1 wt.%Sn alloys during transformation

✍ R.H. Nada 📂 Article 📅 2011 🏛 Elsevier Science 🌐 English ⚖ 373 KB

Effect of tin addition and heat treatment on the work hardening characteristics of Al-2 wt.%Ag alloy during phase transformation has been studied in the deformation temperature range from 503 K to 583 K. The fracture strain ε f , and dislocation slip distance L increased with increasing deformation

The effects of yttrium element on micros

The effects of yttrium element on microstructure and mechanical properties of Mg–5 wt.% Zn–2 wt.% Al alloy

✍ Honghui Zou; Xiaoqin Zeng; Chunquan Zhai; Wenjiang Ding 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 743 KB

Microstructure and oxidation properties

Microstructure and oxidation properties of a neutron-irradiated Cu–13.5 wt% Al–4 wt% Ni shape memory alloy

✍ Rasit Zengin 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 476 KB

Analysis of microstructure formation in

Analysis of microstructure formation in gas-atomised Al–12 wt.% Sn–1 wt.% Cu alloy powder

✍ C.J. Kong; P.D. Brown; S.J. Harris; D.G. McCartney 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 942 KB

Microstructural characteristics and mechanical properties of Al–2.5&#xa0;wt.% Li–1.2&#xa0;wt.% Cu–xMg alloys

Microstructural characteristics and mechanical properties of Al–2.5 wt.% Li–1.2 wt.% Cu–xMg alloys