Microstrip/thick-slot/microstrip transitions in millimeter waves
✍ Scribed by O. Lafond; M. Himdi; J.P. Daniel; N. Haese–Rolland
- Publisher
- John Wiley and Sons
- Year
- 2002
- Tongue
- English
- Weight
- 129 KB
- Volume
- 34
- Category
- Article
- ISSN
- 0895-2477
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
This Letter deals with millimeter microstrip/thick‐slot/microstrip transitions. This kind of transition permits multilayer microstrip antenna arrays to feed. The objectives were to develop and to optimize this transition at 60 GHz, with the use of a low‐loss, low‐cost substrate. A thick ground plane with a slot is introduced between the two substrate layers to rigidify the final structure. Then several transitions were realized and measured in the 60‐GHz band to validate the calculation. © 2002 Wiley Periodicals, Inc. Microwave Opt Technol Lett 34: 100–103, 2002; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.10385
📜 SIMILAR VOLUMES
TABLE 1 rms Delay Spreads and Outage Probabilities for the Rectangular and Arched Buildings with and without Furniture rms Delay Spread rm s Outage Standard Probability Mean Deviation Ž . Ž . Ž . ShapesrParameters ns ns % Empty rectangular room 9.3 0.84 2.5 Rectangular room with 11 2.02 14 furniture
A square-loop slot antenna, printed at the back surface of an extended hemispherical lens, is examined as a candidate for ( ) millimeter-wa¨e mm-wa¨e integrated-circuit Schottky-diode mixers. The loop slot is etched in a microwa¨e substrate, and coupled to a microstrip line section printed on the ot
This paper presents a double slot-line᎐microstrip transition employing a 90Њ cross o¨er them. Using radial stubs at the crosso¨er between the transmission lines, an insertion loss of less than 1.3 dB was ( ) measured 0.65 dB per transition o¨er the 3᎐15 GHz range. The transition is simulated using a
## Abstract The purpose of this paper is to report on a microstrip reconfigurable antenna in the millimeter‐wave range. This antenna has directivity diversity and is based on a four‐element array. An original method is outlined to guarantee matching for each configuration without changing circuit.