๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Method for molding a polymer seal to a rigid pipe

Publisher
Elsevier Science
Year
2005
Tongue
English
Weight
268 KB
Volume
2005
Category
Article
ISSN
1350-4789

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Method and system for applying a seal to
Method and system for applying a seal to a door of a motor vehicle
๐Ÿ“‚ Article ๐Ÿ“… 2008 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 90 KB

An oil seal is described that has a pair of concentric seal lips contained in a rotating housing and a stationary flange between them. The inner lip does not contact the stationary flange when the shaft is stationary but moves to close the gap, presumably due to centrifugal force. A wide selection o

Development of a test method for the rhe
Development of a test method for the rheological characterization of polymers under the injection molding process conditions
โœ P.F. Bariani; M. Salvador; G. Lucchetta ๐Ÿ“‚ Article ๐Ÿ“… 2007 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 242 KB

The reliability of numerical simulations of the injection molding process depends mainly on the rheological characteristics of polymers. The rheological characterization of a polymer for injection molding is commonly carried out by a capillary rheometer. However, in this method the measurement is ca