𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Mechanism of weld line formation in injection molding of plastics

✍ Scribed by A. V. Enikeev; Yu. V. Kazankov; V. A. Mironov

Publisher
Springer
Year
1999
Tongue
English
Weight
419 KB
Volume
35
Category
Article
ISSN
0009-2355

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Failure and fracture mechanisms of injec
Failure and fracture mechanisms of injection-molded plastic products
✍ M. J. M. Van Der Zwet; A. J. Heidweiller πŸ“‚ Article πŸ“… 1998 πŸ› John Wiley and Sons 🌐 English βš– 474 KB πŸ‘ 2 views

The effect of geometry transitions on the mechanical load-carrying ability of specimens has been studied. Special attention has been given to a potentially positive influence of the injection molding process. Tensile tests, three-point bending tests, and low cycle fatigue tests were performed on spe

Simulation of microstructure development
Simulation of microstructure development in injection molding of engineering plastics
✍ Jeong S. Yu; Alan H. Wagner; Dilhan M. Kalyon πŸ“‚ Article πŸ“… 1992 πŸ› John Wiley and Sons 🌐 English βš– 829 KB

Mathematical models were developed to predict the various microstructural properties, including birefringence, residual stress, and density distributions, in the freely quenched compression molded samples as well as in the injection molded samples. To model the birefringence distribution in the inje