๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Heat transfer in injection molding of crystalline plastics

โœ Scribed by Yu Bai; Bo Yin; Xia-rong Fu; Min-gbo Yang

Publisher
John Wiley and Sons
Year
2006
Tongue
English
Weight
198 KB
Volume
102
Category
Article
ISSN
0021-8995

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Failure and fracture mechanisms of injec
Failure and fracture mechanisms of injection-molded plastic products
โœ M. J. M. Van Der Zwet; A. J. Heidweiller ๐Ÿ“‚ Article ๐Ÿ“… 1998 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 474 KB

The effect of geometry transitions on the mechanical load-carrying ability of specimens has been studied. Special attention has been given to a potentially positive influence of the injection molding process. Tensile tests, three-point bending tests, and low cycle fatigue tests were performed on spe

Review of research in the determination
Review of research in the determination of process parameters for plastic injection molding
โœ S. L. Mok; C. K. Kwong; W. S. Lau ๐Ÿ“‚ Article ๐Ÿ“… 1999 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 228 KB ๐Ÿ‘ 2 views

This article aims to review the research in determining process parameters of injection molding. A number of research works based on various approaches have been performed in the domain of the parameter setting for injection molding. These approaches, including mathematical models, numerical simulat

Experimental investigation of infrared r
Experimental investigation of infrared rapid surface heating for injection molding
โœ Pei-Chi Chang; Sheng-Jye Hwang ๐Ÿ“‚ Article ๐Ÿ“… 2006 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 395 KB

## Abstract A low cost and practical infrared rapid surface heating system for injection molding is designed and investigated. The system was designed to assemble on the mold and a control system was used to operate the motion of the lamp holder. Four infrared halogen lamps (1 kW each) were used as