๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Mechanical properties of ABS/polycarbonate blends

โœ Scribed by H. Suarez; J. W. Barlow; D. R. Paul

Publisher
John Wiley and Sons
Year
1984
Tongue
English
Weight
377 KB
Volume
29
Category
Article
ISSN
0021-8995

No coin nor oath required. For personal study only.

โœฆ Synopsis

The mechanical properties of extruder compounded blends of ABS and polycarbonate in the form of extruded-sheet and injection-molded bars are reported and compared with commercial products based on these components. The modulus and tensile yield strength exhibit a nearly additive response to blend composition while percent elongation at break shows a minimum vs. composition. Notched Izod impact strength is nearly constant at the level of pure ABS up to 50% polycarbonate and increases rapidly upon further addition of polycarbonate.

๐Ÿ“œ SIMILAR VOLUMES

Mechanical properties of blends of polyc
Mechanical properties of blends of polycarbonate with unmodified and maleic anhydride grafted ABS
โœ Balakrishnan, S.; Neelakantan, N. R. ๐Ÿ“‚ Article ๐Ÿ“… 1998 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 310 KB ๐Ÿ‘ 2 views

Blends of polycarbonate/acrylonitrileรˆbutadieneรˆstyrene terpolymer (PC/ABS) and polycarbonate/maleic anhydride grafted ABS (PC/MABS) were prepared over the whole range of compositions using a single-screw extruder. Tensile, ร‘exural, notched Izod impact properties, and the heat deร‘ection temperature

Morphological, thermal, and mechanical p
Morphological, thermal, and mechanical properties of polypropylene/polycarbonate blend
โœ Yin Zhihui; Zhang Xiaomin; Zhang Yajie; Yin Jinghua ๐Ÿ“‚ Article ๐Ÿ“… 1997 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 284 KB ๐Ÿ‘ 2 views

This work deals with the effect of compatibilizer on the morphological, thermal, rheological, and mechanical properties of polypropylene/polycarbonate (PP/ PC) blends. The blends, containing between 0 to 30 vol % of polycarbonate and a compatibilizer, were prepared by means of a twin-screw extruder.

Mica as a filler for ABS/polycarbonate b
Mica as a filler for ABS/polycarbonate blends
โœ M. T. Pastorini; R. C. R. Nunes ๐Ÿ“‚ Article ๐Ÿ“… 1999 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 124 KB ๐Ÿ‘ 1 views

Mica was incorporated in ABS/PC:65/35 blends prepared on a Haake Torque Rheometer System 9000 with Rheomix 600 mixer. To improve the polymer/filler interaction, a treatment using silane on mica surface was performed. Studies were conducted concerning mechanical properties (flexural and impact streng