✦ LIBER ✦

Investigations on heat transfer in a plate evaporator

✍ Scribed by H.R. Engelhorn; A.M. Reinhart

Publisher: Elsevier Science
Year: 1990
Tongue: English
Weight: 325 KB
Volume: 28
Category: Article
ISSN: 0255-2701
DOI: 10.1016/0255-2701(90)80011-s

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Design of a plate-type evaporator for he

Design of a plate-type evaporator for heat pumps

✍ H.T Haukås 📂 Article 📅 1984 🏛 Elsevier Science 🌐 English ⚖ 439 KB

Analysis of heat transfer in a centrifug

Analysis of heat transfer in a centrifugal film evaporator

✍ S. Bruin 📂 Article 📅 1970 🏛 Elsevier Science 🌐 English ⚖ 757 KB

Heat transfer in a centrifugal film evaporator with a conical heating surface is analysed. Two regions of transfer can be distinguished: an entrance region, where the temperature profile in the film develops, and an evaporation region, where "surface evaporation" takes place. Relations are derived f

Note on conjugated heat transfer in a fl

Note on conjugated heat transfer in a flat plate

✍ R. Karvinen 📂 Article 📅 1978 🏛 Elsevier Science ⚖ 129 KB

Influence of vibrating element on heat t

Influence of vibrating element on heat transfer in a thin layer evaporator

✍ A. Skoczylas; A. Urbański 📂 Article 📅 1992 🏛 Elsevier Science ⚖ 793 KB

Heat transfer in a reciprocating plate c

Heat transfer in a reciprocating plate column

✍ Nadella V. Rama Rao; Malcolm H. I. Baird 📂 Article 📅 2000 🏛 John Wiley and Sons 🌐 English ⚖ 790 KB

Some considerations on heat transfer in

Some considerations on heat transfer in spiral plate heat exchangers

✍ M.H.I. Baird; W. McCrae; F. Rumford; C.G.M. Slesser 📂 Article 📅 1957 🏛 Elsevier Science 🌐 English ⚖ 347 KB

The sea-water samples used had a chlorinity of 16 and were obtained from the Firth of Clyde near the entrance to Loch Long. Their surface tension at IOWC was found to be 58.7 dyn/cm, as compared with 71.8 dyn/cm for a sample of freshwater. The freshwater used for comparison was Glasgow City water.