✦ LIBER ✦

Injection moulding of reinforced thermosets

✍ Scribed by Wang, Jing; Xu, Zhijie

Book ID: 122405853
Publisher: Elsevier Science
Year: 1987
Tongue: English
Weight: 86 KB
Volume: 17
Category: Article
ISSN: 0306-3747
DOI: 10.1016/0306-3747(87)90003-0

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Injection moulding of reinforced thermop

Injection moulding of reinforced thermoplastics and thermosets

✍ Coupland, R.M; Hoikka, V; Sjoeklint, O.G; Cuenod, P; Cauderay, G.C; Doswald-Beck 📂 Article 📅 1987 🏛 Elsevier Science 🌐 English ⚖ 93 KB

Injection moulding of reinforced thermos

Injection moulding of reinforced thermosets compared with reinforced thermoplastics; a current appraisal: Wood, R. P. Plastics and Polymers, Vol 39, No 139, pp 57–64 (February 1971)

📂 Article 📅 1971 🏛 Elsevier Science ⚖ 148 KB

Residual stresses in short-glass-fibre-r

Residual stresses in short-glass-fibre-reinforced thermoset injection mouldings

✍ S. B Wilkinson; J. R White 📂 Article 📅 1998 🏛 Springer 🌐 English ⚖ 181 KB

Injection moulded glass fibre reinforced

Injection moulded glass fibre reinforced thermoplastics & thermosets in automobiles

📂 Article 📅 1987 🏛 Elsevier Science 🌐 English ⚖ 98 KB

Injection moulding of thermosets. Effect

Injection moulding of thermosets. Effect of the temperature of injection

✍ H. Hadi; K. Azaar; A. El Brouzi; R. Granger; J.M. Vergnaud 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 491 KB

In order to reduce the cycle time of cure of thermosets, one of the best method is to use a system of injection moulding. This system enables one to inject the thermoset at a higher temperature than room temperature in the heated mould. Thus the heating period of the resin may be significantly reduc

New thermoset for injection moulding

📂 Article 📅 1971 🏛 Elsevier Science ⚖ 134 KB