๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Influence of the conditions of processing on the formation of the phase structure of elastomer mixtures

โœ Scribed by Yu.P. Miroshnikov; O.V. Kamynina

Book ID
116048215
Publisher
Elsevier Science
Year
1987
Weight
661 KB
Volume
29
Category
Article
ISSN
0032-3950

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Influence of crosslinking conditions on
Influence of crosslinking conditions on the phase behavior of a polyacrylate-based liquid-crystalline elastomer
โœ Eugene R. Zubarev; Raissa V. Talroze; Tatyana I. Yuranova; Victor N. Vasilets; N ๐Ÿ“‚ Article ๐Ÿ“… 1996 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 343 KB ๐Ÿ‘ 1 views

## Abstract The influence of crosslinking conditions (ฮณโ€radiationโ€induced and chemical crosslinking above and below the clearing point) on the phase behavior of a liquidโ€crystalline polyacrylateโ€based elastomer is shown and discussed. The network formation in samples ฮณโ€irradiated in the nematic pha

Influence of the synthesis conditions on
Influence of the synthesis conditions on the properties of thermoplastic polyurethane elastomers
โœ M. S. Sรกnchezโ€“Adsuar; E. Papon; J-J. Villenave ๐Ÿ“‚ Article ๐Ÿ“… 2000 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 133 KB ๐Ÿ‘ 2 views

Thermoplastic polyurethane elastomers (TPUs) of constant composition were prepared by using the prepolymer method and by changing the reaction conditions (prepolymerization and chain-extension time) to study the influence of these conditions on the final TPU properties. The TPUs were characterized b

The influence of air-gap conditions on t
The influence of air-gap conditions on the structure formation of lyocell fibers
โœ S. A. Mortimer; A. A. Peguy ๐Ÿ“‚ Article ๐Ÿ“… 1996 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 822 KB

The influence of a n air gap on the formation of a filament spun from a solution of cellulose in N-methylmorpholine N-oxide was studied. A number of parameters were investigated, principally, air-gap length, temperature, and humidity and the water content in the polymer solution. Their effect on the