✦ LIBER ✦

Influence of mold design on the mechanical properties of high-pressure injection—molded polyethylene

✍ Scribed by J. Kubáut; J.-A. Månson; M. Rigdahl

Publisher: Society for Plastic Engineers
Year: 1983
Tongue: English
Weight: 580 KB
Volume: 23
Category: Article
ISSN: 0032-3888
DOI: 10.1002/pen.760231604

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Influence of mold filling rate and gate

Influence of mold filling rate and gate geometry on the modulus of high pressure injection-molded polyethylene

✍ A. Boldizar; J. Kubát; M. Rigdahl 📂 Article 📅 1990 🏛 John Wiley and Sons 🌐 English ⚖ 487 KB 👁 1 views

High pressure injection molding of HDPE with relatively high molecular weight is known to give products with significantly increased modulus and strength. The extent of this improvement is reduced when the thickness of the molded sample increases. The present paper is an account of experiments with

Properties of elongational flow injectio

Properties of elongational flow injection-molded polyethylene. Part 1: Influence of mold geometry

✍ R. K. Bayer; H. G. Zachmann; F. J. Baltá Calleja; H. Umbach 📂 Article 📅 1989 🏛 Society for Plastic Engineers 🌐 English ⚖ 625 KB

Influence of injection parameters and mo

Influence of injection parameters and mold materials on mechanical properties of ABS in plastic injection molding

✍ Babur Ozcelik; Alper Ozbay; Erhan Demirbas 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 239 KB

The effect of annealing at 135° on the m

The effect of annealing at 135° on the mechanical properties of injection molded high density polyethylene-polypropylene blends

✍ R. A. Varin; D. Djokovic 📂 Article 📅 1988 🏛 Society for Plastic Engineers 🌐 English ⚖ 759 KB

Properties of elongational flow injectio

Properties of elongational flow injection-molded polyethylene part 2: Influence of processing parameters

✍ E. López Cabarcos; R. K. Bayer; H. G. Zachmann; F. J. Baltá Calleja; W. Meins 📂 Article 📅 1989 🏛 Society for Plastic Engineers 🌐 English ⚖ 634 KB

Morphology and mechanical properties of

Morphology and mechanical properties of injection-molded ultrahigh molecular weight polyethylene/polypropylene blends and comparison with compression molding

✍ Meiju Xie; Jinyao Chen; Huilin Li 📂 Article 📅 2008 🏛 John Wiley and Sons 🌐 English ⚖ 380 KB 👁 2 views