𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Influence of initial curing on sulphate resistance of blended cement concrete

✍ Scribed by P.S. Mangat; J.M. El-Khatib


Publisher
Elsevier Science
Year
1992
Tongue
English
Weight
738 KB
Volume
22
Category
Article
ISSN
0008-8846

No coin nor oath required. For personal study only.

✦ Synopsis


The paper presents results of an investigation on the effect of initial curing conditions on the sulphate resistance of concrete made with ordinary portland cement and using pfa, silica fume and ground granulated blast furnace slag for partial replacement of cement. In addition, porosity and pore structure analysis of representative pastes was carried out to examine the relationship between these properties and sulphate resistance of concrete. The depth of carbonation in specimens of pastes was also determined.

Three different initial curing conditions immediately after casting of specimens were adopted, namely: WET/AIR CURED at 450C, 25% RH; AIR CURED at 45"C, 25% RH; AIR CURED at 20"C, 55% RH. The results show that pore volume and pore structure of the paste bear no direct relationship with the sulphate resistance of concrete. The presence of a carbonated layer on the surface is generally accompanied by superior sulphate resistance -there are, however, important exceptions. Low humidity curing at high temperature (45"C) results in higher depths of carbonation but lower sulphate resistance than similar curing at 20"C.

The sulphate resistance of concrete increases with the replacement of cement with 22% pfa, 9% silica fume and 80% ggb slag. The sulphate resistance also increases due to drying out of concrete during early curing at low relative humidity and due to carbonation. The possible common factor which leads to this improved sulphate resistance is the reduced Ca(OH)2 content which leads to smaller volume of the expansive reaction products with sulphate ions. The effect of initial curing at high temperature (45 Β° C) is significantly harmful to the sulphate resistance of plain concrete but much less so to the blended cement concretes.


πŸ“œ SIMILAR VOLUMES


Studies about a sulphate resistant cemen
✍ M.T. Blanco; S. GarcΓ­a; S. GimΓ©nez; A. Palomo; F. Puertas; T. VΓ‘zquez πŸ“‚ Article πŸ“… 1994 πŸ› Elsevier Science 🌐 English βš– 377 KB

Starting from an industrial cement obtained by milling together a new low energy clinker and gypsum, two blended cements containing 20% wt of fly ashes and 10% wt of limestone respectively, have been prepared. The behaviour of these three cements in Na2SO 4 dissolution and sea water has been studied

The influence of humidity and curing tim
✍ D.W.S. Ho; Q.Y. Cui; D.J. Ritchie πŸ“‚ Article πŸ“… 1989 πŸ› Elsevier Science 🌐 English βš– 414 KB

The quality of concrete is improved by curing but the amount of improvement depends on both the associated environment and curing time. Much has been written on the influence of environmental hurrfidity on cement hydration but information is lacking on the duration required to achieve certain levels

The applications of aluminous cement and
✍ Hussey, A. Vivian πŸ“‚ Article πŸ“… 1936 πŸ› Wiley (John Wiley & Sons) βš– 941 KB

Paper read before the Road and Building Materials Group o f the Society on Tuesday, November 10, 1936 :\1>l)iircIitly the airliest, publiciitioii referring to tests on :ilriiiiiiious ccriiciit iii this country nppciiretl ~I I n l)ii1)~r I)y D n \ ~y l in 1923, ciititlctl " Soiiic Notes 011 \* Ciiiic