✦ LIBER ✦

In-situ temperature measurements in the depths of injection molded parts

✍ Scribed by Shih-Jung Liu; Po-Chang Su; Kun-Yeh Lin

Book ID: 104047596
Publisher: Elsevier Science
Year: 2009
Tongue: English
Weight: 480 KB
Volume: 42
Category: Article
ISSN: 0263-2241
DOI: 10.1016/j.measurement.2009.01.002

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Temperature measurements in the depth an

Temperature measurements in the depth and at the surface of injected thermoplastic parts

✍ Youssef Farouq; Cécile Nicolazo; Alain Sarda; Rémi Deterre 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 614 KB

Prediction and measurement of residual s

Prediction and measurement of residual stresses in injection molded parts

✍ Young Il Kwon; Tae Jin Kang; Kwansoo Chung; Jae Ryoun Youn 📂 Article 📅 2001 🏛 The Korean Fiber Society 🌐 English ⚖ 221 KB

An Investigation of Weldline Strength in

An Investigation of Weldline Strength in Injection Molded Rubber Parts

✍ Chookaew, Watcharapong; Mingbunjurdsuk, Jirachai; Jittham, Pairote; Ranong, Nuch 📂 Article 📅 2013 🏛 Elsevier ⚖ 985 KB

Temperature measurements of polymer melt

Temperature measurements of polymer melts in the heating barrel during injection molding. Part 2: Three-dimensional temperature distribution in the reservoir

✍ O. Amano; S. Utsugi 📂 Article 📅 1989 🏛 Society for Plastic Engineers 🌐 English ⚖ 565 KB

Effects of insert film on asymmetric mol

Effects of insert film on asymmetric mold temperature and associated part warpage during in-mold decoration injection molding of PP parts

✍ Chen, Hui-Li; Chen, Shia-Chung; Liao, Won-Hsion; Chien, Rean-Der; Lin, Yu-Tseng 📂 Article 📅 2013 🏛 Elsevier Science 🌐 English ⚖ 937 KB

Temperature measurements of polymer melt

Temperature measurements of polymer melts in the heating barrel during injection molding. Part 3: Effects of screw geometry

✍ Osamu Amano; Shirou Utsugi 📂 Article 📅 1990 🏛 Society for Plastic Engineers 🌐 English ⚖ 707 KB

## Abstract We have developed a new method to measure the true temperature of the polymer melt and its three‐dimensional distribution of a shot stored in the reservoir during injection. By means of this method, it is demonstrated that the temperature distribution of the polymer melt stored in the r