𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Effects of insert film on asymmetric mold temperature and associated part warpage during in-mold decoration injection molding of PP parts

✍ Scribed by Chen, Hui-Li; Chen, Shia-Chung; Liao, Won-Hsion; Chien, Rean-Der; Lin, Yu-Tseng

Book ID
121240860
Publisher
Elsevier Science
Year
2013
Tongue
English
Weight
937 KB
Volume
41
Category
Article
ISSN
0735-1933

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Integrated simulations of structural per
Integrated simulations of structural performance, molding process, and warpage for gas-assisted injection-molded parts. III. Simulation of cyclic, transient variations in mold wall temperatures
✍ Shia-Chung Chen; Sheng-Yan Hu; Wen-Ren Jong πŸ“‚ Article πŸ“… 1999 πŸ› John Wiley and Sons 🌐 English βš– 576 KB

Whether it is feasible to perform an integrated simulation for structural analysis, process simulation, as well as warpage calculation based on a unified CAE model for gas-assisted injection molding (GAIM) is a great concern. In the present study, numerical algorithms based on the same CAE model use

Temperature measurements of polymer melt
Temperature measurements of polymer melts in the heating barrel during injection molding. Part 3: Effects of screw geometry
✍ Osamu Amano; Shirou Utsugi πŸ“‚ Article πŸ“… 1990 πŸ› Society for Plastic Engineers 🌐 English βš– 707 KB

## Abstract We have developed a new method to measure the true temperature of the polymer melt and its three‐dimensional distribution of a shot stored in the reservoir during injection. By means of this method, it is demonstrated that the temperature distribution of the polymer melt stored in the r

Effect of crystallization and interface
Effect of crystallization and interface formation mechanism on mechanical properties of film-insert injection-molded poly(propylene) (PP) film/PP substrate
✍ S. Yamaguchi; Y. W. Leong; T. Tsujii; M. Mizoguchi; U. S. Ishiaku; H. Hamada πŸ“‚ Article πŸ“… 2005 πŸ› John Wiley and Sons 🌐 English βš– 358 KB πŸ‘ 2 views

## Abstract A previous study has shown that the adhesion between the film and substrate of film‐insert injection‐molded poly(propylene) (PP) film/PP substrate was evident with the increases in barrel temperature and injection holding pressure. In this second part of the research work, the crystalli