𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Improving impedance characteristics for small monopole antennas

✍ Scribed by Jinwoo Jung; Hyeonjin Lee; Yeongseog Lim

Publisher
John Wiley and Sons
Year
2009
Tongue
English
Weight
532 KB
Volume
51
Category
Article
ISSN
0895-2477

No coin nor oath required. For personal study only.

✦ Synopsis

Abstract

Small monopole antennas like meander‐line antennas and normal‐mode helical antennas are used for handsets in personal communication systems. Because the radiation resistance of small monopole antennas is low, the impedance characteristics are a problem. In this article, we analyzed the relation of monopole antennas and their ground planes to current distribution, and we proposed methods to improve the impedance characteristics of small monopole antennas with low radiation resistance. The impedance characteristics of monopole antennas vary according to the feeding point and the width of the ground plane. Our analysis indicates that varying these impedance characteristics can be used to improve the impedance characteristics of small monopole antennas. The printed meander‐line monopole antenna and the stacked helix monopole antenna were used for experimentation. © 2009 Wiley Periodicals, Inc. Microwave Opt Technol Lett 51: 836–842, 2009; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.24151

📜 SIMILAR VOLUMES

An asymmetrical feed arrangement for imp
An asymmetrical feed arrangement for improved impedance bandwidth of planar monopole antennas
✍ M. J. Ammann; Zhi Ning Chen 📂 Article 📅 2003 🏛 John Wiley and Sons 🌐 English ⚖ 95 KB

## Abstract The use of an asymmetrical feed probe is shown to significantly increase the impedance bandwidth of a square planar monopole antenna. The feed probe is offset from the center of the planar element. The optimum location of the feed probe is shown to increase the impedance bandwidth by a

Note on impedance characteristics of L-s
Note on impedance characteristics of L-shaped wire monopole antenna
✍ Zhi Ning Chen 📂 Article 📅 2000 🏛 John Wiley and Sons 🌐 English ⚖ 111 KB

The impedance characteristics of an L-shaped wire monopole antenna are experimentally in¨estigated. The effect of different ratios of the horizontal arm length to the height of the L-shaped monopole on the impedance characteristics is discussed. The in¨estigation demonstrates how a monopole with an

Analyzing impedance characteristics of m
Analyzing impedance characteristics of monopole antennas with different chassis widths for dual resonance-based broadband operation
✍ Jinwoo Jung; Hyeonjin Lee; Yeongseog Lim 📂 Article 📅 2010 🏛 John Wiley and Sons 🌐 English ⚖ 228 KB

## Abstract Variation of the impedance characteristics between two monopole antennas, according to the width of chassis is analyzed. Dual resonance‐based broadband antennas are proposed on the basis of the analyzed results. The experimental antennas are an inverted L‐shaped monopole antenna and a p

Optimization of impedance bandwidth for
Optimization of impedance bandwidth for the printed rectangular monopole antenna
✍ M. John; M. J. Ammann 📂 Article 📅 2005 🏛 John Wiley and Sons 🌐 English ⚖ 81 KB

This paper describes a printed rectangular-plate monopole fed by microstrip line. The effect of varying the plate width, feedgap height, and feedline width on the impedance bandwidth is examined. It is shown that for a fixed ground-plane size, that optimization of these parameters can yield an imped

Small microstrip-fed printed monopole an
Small microstrip-fed printed monopole antenna for UWB application
✍ M. Ojaroudi; H. Ebrahimian; Ch. Ghobadi; J. Nourinia 📂 Article 📅 2010 🏛 John Wiley and Sons 🌐 English ⚖ 791 KB

## Abstract In this article by using the Babinet's Equivalence Principle and self‐complementary structure, we present a novel printed monopole antenna for ultra‐wideband (UWB) applications. The proposed antenna consists of a ground plane and radiating patch with a slot and a sleeve structure, which